Chapter II
4.6.
ZOOM key
You can press this key to expand the bargraph readout five times for positive measurements
and eleven times for bipolar measurements, one centred around zero (centre zero mode).
Adjusts ohm-value references in dB and resistive power measurements
When the current measurement is dB or resistive power, you can display the resistance
reference with the ZOOM key (long press). This value can then be adjusted using the
SEL/ON and RANGE keys (this value is common to dBm and resistive power
measurements).
You quit the ohm reference adjustment mode with the ZOOM key (short press).
4.7.
SURV key
If you press this key (long press), you access the surveillance mode (or coming out), in
which minimum (MIN), maximum (MAX) and sliding average (AVG) values of the current
measurement are stored (capture time ≤ 500 ms).
You can look up each of these values by repeatedly pressing the same key (short press).
The symbols MIN, MAX or AVG flicker with the selected value.
"
Note
When entering in the SURV mode, non-coherent values may be displayed.
4.8.
Hz key
When the current positions are V
- frequency measurement,
- positive duty cycle measurement (% +),
- negative duty cycle measurement (% -),
- positive pulse count (
- negative pulse count (
- positive pulse width measurements (
- negative pulse width measurements (
A long press on Hz key allows a direct selection of the voltage or current function.
4.9.
PRINT key (for use with optional interface accessory for printer or PC)
Short press :
Long press :
4.10.
key
Activates / deactivates back lighting of the display unit. It automatically goes off after about
30 seconds.
30
, V
AC
DC
)
)
Activates/deactivates « send measurements to printer » mode at the rate
defined by the user.
Adjusts the rate varying from 00000 sec (a single transmission) up to 9h
59 min. 59 sec, using the SEL/ON key (selection of digits) and the range
key (increment the selected digit).
, mV, mA and 10 A, the Hz key invokes, in turn :
)
)
Portable digital multimeter