How To Achieve Optimal Results; Maintenance Phase; Possible Side Effects And Skin Reactions - Philips Lumea Precision Plus SC2008 Manual De Instrucciones

ENGLISH
22

How to achieve optimal results

- It is normal that hairs are still visible after the first few treatments (see
chapter 'Introduction', section 'Working principle' for more information).
- To remove all hairs successfully and prevent the hair follicle from
becoming active again, the treatments have to be repeated once every
two weeks for the first two months. Your skin should be smooth by
then. Please read section 'Maintenance phase' to find out how you
can keep these results.

Maintenance phase

- To ensure that your skin stays smooth, we advise you to repeat the
treatment every 4 to 8 weeks. The time between treatments may vary
based on your individual hair regrowth and also across different body
areas. If too many hairs grow back between treatments, simply shorten
the treatment interval again, but do not treat any area more often than
once every two weeks. When you use the appliance more frequently
than recommended, you do not increase the effectiveness but you do
increase the risk of skin reactions.

Possible side effects and skin reactions

Common skin reactions:
- Your skin may show slight redness and/or may prickle, tingle or feel
warm. This reaction is absolutely harmless and disappears quickly.
- A skin reaction similar to sunburn may occur on the treated area for a
short while. If this does not disappear within 3 days, we advise you to
consult a doctor.
- Dry skin and itching may occur because of the combination of shaving
and light treatment. This is harmless and disappears within a few days.
You can cool the area with an ice pack or a wet facecloth. If dryness
persists, you can apply a non-scented moisturiser on the treated area
24 hours after the treatment.
Rare side effects:
- Burns, excessive redness and swelling: these reactions occur very rarely.
They are the result of using a light intensity that is too high for your
skin colour. If these reactions do not disappear within 3 days, we advise
you to consult a doctor. Wait with the next treatment until the skin has
healed completely and make sure you use a lower light intensity.
- Skin discolouration: this occurs very rarely. Skin discolouration manifests
itself as either a darker patch (hyperpigmentation) or a lighter patch
(hypopigmentation) than the surrounding area. This is the result of using
a light intensity that is too high for your skin colour. If the discolouration
does not disappear within 2 weeks, we advise you to consult a doctor.
Do not treat discoloured areas until the discolouration has disappeared
and your skin has regained its normal skin colour.
- Skin infection and inflammation: This occurs very rarely and may be
caused by using the appliance on wounds or cuts that resulted from
shaving, on already existing wounds or on ingrown hairs.
- Excessive pain: this can occur during or after treatment if you have
used the appliance on unshaved skin, if you use the appliance at a light
intensity that is too high for your skin colour, if you flash the same
area more than once and if you use the appliance on open wounds,
inflammations, infections, tattoos, burns, etc. See chapter 'Important',
section 'Contraindications' for more information.