Ryobi RY09600 Manual Del Operador página 13

STARTING AND STOPPING
See Figures 9 - 11.
When starting the product for the first time or when the bat-
tery voltage is low, it may be necessary to manually start
this product.
FOR ELECTRIC START:
To start a cold engine:
DO NOT engage the throttle until the engine starts and
runs.
 Lay the product on a flat, bare surface.
 PRIME - Press the primer bulb 7 times.
 SET the start lever to the START position.
 PRESS ignition switch.
 Push the throttle to run.
NOTE: Engaging and releasing the throttle releases the start
lever to the RUN position.
To start a warm engine:
 PRESS ignition switch.
To stop the engine:
 Press and hold the switch in the stop "
the engine stops.
FOR MANUAL START:
To start a cold engine:
DO NOT engage the throttle until the engine starts and
runs.
 Lay the product on a flat, bare surface.
 PRIME - Press the primer bulb 7 times.
 SET the start lever to the START position.
 PULL the recoil starter until the engine starts.
 Push the throttle to run.
NOTE: Engaging and releasing the throttle releases the start
lever to the RUN position.
To start a warm engine:
 PULL the recoil starter until the engine starts.
To stop the engine:
 Press and hold the switch in the stop "
the engine stops.
IF ASSISTANCE IS REqUIRED STARTING THIS
PRODUCT:
Do not return this product to the retail store where it was
purchased. Please call our Customer Service Department
for any issues you may have.
For Help Call: 1-800-860-4050.
OPERATION
Keep away from all hot surfaces of the blower. Failure to
do so could result in possible serious personal injury.
OPERATING THE BLOWER
See Figure 12.
 Slip arm through harness strap and onto shoulder, then
repeat for the other shoulder. Adjust the straps to a
comfortable position. Refer to Adjusting Harness Straps
earlier in this manual. Remove unit for starting.
 Start the blower. Refer to Starting and Stopping earlier in this manual.
 Put on the blower again. The unit should be operated on
the operator's right side as shown.
 To keep from scattering debris, blow around the outer
edges of a debris pile. Never blow directly into the center
of a pile.
 Operate power equipment at reasonable hours only —
not early in the morning or late at night when people
might be disturbed. Comply with the times listed in local
" position until
ordinances.
 To reduce sound levels, limit the number of pieces of
equipment used at any one time.
 Operate blower at the lowest possible throttle speed to
do the job.
 Check your equipment before operation, especially the
muffler, air intakes, and air filters.
 Use rakes and brooms to loosen debris before blowing.
In dusty conditions, slightly dampen surfaces when water
is available.
 Conserve water by using power blowers instead of hoses
for many lawn and garden applications, including areas
such as gutters, screens, patios, grills, porches, and
gardens.
 Watch out for children, pets, open windows, or freshly
washed cars, and blow debris safely away.
 Use the wide sweeper nozzle for larger volume, so the
air stream can work close to the ground.
" position until
 After using blowers or other equipment, CLEAN UP!
Dispose of debris properly.
CAUTION:
Do not place blower on top of or near loose debris.
Debris may be sucked into blower intake vent resulting
in possible damage to the unit.
11 — English
WARNING: