RIDGID R4020 Manual Del Operador página 20

OPERATION
TO MAKE A BEVEL CUT
See Figures 19 - 20.
Beveled 22.5° and 45° cuts can be made using the bevel
table.
 Using a marker or grease pencil, mark the area to be cut
on material.
 Remove the rip guide.
 Tilt the bevel table.
 On underside of bevel table, pull down the table legs into
right angles of the plate.
• Use first notches in legs to rest plate into 22.5°
angle.
• Use second set of notches to angle bevel table
into highest 45° angle.
NOTE: Make sure bevel table is locked firmly in
place before beginning cut
 Turn the on/off switch to the ON position.
 Let the cutting wheel build up to full speed and wait for
the wheel to get wet before moving the material into the
wheel.
 Hold the material firmly against the bevel table and feed
the material into the cutting wheel.
 When the cut is made, turn the saw OFF. Wait for the
cutting wheel to come to a complete stop before removing
any part of the material.
22.5º BEVEL
NOTCH
45º BEVEL
NOTCH
TABLE
LEGS
20 — English
BEVEL
TABLE
BEVEL CUT
Fig. 19
Fig. 20