RIDGID R4020 Manual Del Operador página 13

ASSEMBLY
 Unplug the saw and remove the bevel table.
 Place the wheel wrench on the arbor nut then slide the
arbor wrench onto the arbor.
 Holding the arbor wrench firmly to prevent the wheel from
moving, pull the wrench (left side) forward to the front of
the machine to loosen.
 Remove the arbor nut and outer washer leaving the inner
washer on the arbor.
WARNING:
Always install the inner wheel washer before plac-
ing wheel on arbor. Failure to do so could cause an
accident since the wheel will not tighten properly.
Never use wheels that have openings, grooves, or
teeth on this tool.
 Place the cutting wheel onto arbor with the arrows on
wheel going in the counterclockwise direction.
 Replace the outer washer. The double "D" flats on the
washers align with the flats on the arbor.
 Replace the arbor nut on the arbor. Using wheel wrench
and arbor wrench, tighten arbor nut securely.
INSTALLING THE SPLASH HOOD
See Figure 7 - 8.
 Remove the bevel table.
 Loosen and remove the screws.
 Slide the L-shaped splash hood bracket into the lip under
the table behind the cutting wheel.
 Reinstall the screws through the table and into the splash
hood bracket. Tighten securely.
NOTE: Align the hood bracket with the cutting wheel so
that it does not interfere with the material being cut.
 Slide the splash hood over the bracket and align the holes
in splash hood with the slot in the splash hood bracket.
 Insert the hex bolt through hood and bracket. Thread the
splash hood knob onto the bolt and tighten to the desired
height.
NOTE: Always adjust the splash hood horizontally to the
table and slightly above tile thickness. Hood should not
touch the tile.
LIP
SCREWS
SPLASH HOOD
KNOB
SPLASH
HOOD
13 — English
SPLASH HOOD
BRACKET
SPLASH HOOD
Fig. 7
HEX
BOLT
BRACKET
Fig. 8