Toilet Tank Fill Valve Instructions - Toto CST243EF Manual De Instrucciones

5) Flush the water supply line for a few seconds
to remove any debris that may enter the
new fill valve. (For new home constructions
and/or additions, flush the water supply line
for more than a minute to help remove any
residual PVC adhesives, solder flux, and/
or pipe sealants that were used for the new
plumbing.) Connect the water supply line to
the fill valve threads as seen at the bottom
of toilet tank (see Illustration 7). Tighten this
connection finger tight.
CA UTION: Avoid using a wrench to tighten
the connection as you may damage the
plastic threads and/or cause the fill valve
to rotate inside the tank.
NO TE: The water supply pressure should be
20 to 80 psi static.
6) No ballcock / fill valve adjustments are
needed. The water will automatically stop at
proper level.
Flush the toilet several times. Check flapper
valve for proper operation. Make sure that
chain is not tangled and that the flapper arm
is in its proper position.
7) Install the toilet tank lid onto the toilet tank
top.
8) Install the toilet seat onto the toilet bowl
using the mounting hardware in the toilet
seat box. Place seat onto bowl and rotate the
hinge down. Position seat stoppers under
the seat hinge. Insert bolt into seat hinge
and through the toilet bowl. Install plastic nut
onto bolt from underneath. Tighten the bolt
securely. Install the seat bolt caps.
NO TE: Tighten the seat bolt until the hinge
is secure. The seat and lid will have slight
side to side movement, which is normal.
This freedom of movement allows the
seat to SoftClose® without binding.

TOILET TANK FILL VALVE INSTRUCTIONS

1) Shut off the water supply to the toilet.
2) Flush toilet and remove remaining water from tank with a sponge.
3) Remove the water supply connection at the fill valve.
4) Remove old fill valve and use damp sponge to clean hole in tank.
Installation Procedures (continued)
Installation Procedure
Ill. 8
Seat
Hinge
5
Ill. 7
7/8" Ballcock Thread
HAND TIGHTEN ONLY
Cap
Plastic
Bolt
Seat
Stopper
Bowl
Plastic Nut
MOUNTING HARDWARE
1
3
2
4
5
1 - Cap
2 - Plastic Bolt
3 - Seat Hinge
4 - Seat Stopper
5 - Toilet Bowl
6 - Plastic Nut
6