Skil HD527801 Manual Del Propietário página 16

LED Worklight (Fig . 8)
Your tool is equipped with an LED worklight,
located on the base of the tool, that illuminates
when the variable-speed trigger switch is
squeezed. This provides additional light on the
surface of the workpiece for operation in lower-
light areas.
The LED worklight will automatically turn on
with a slight squeeze on the variable-speed
trigger switch before the tool starts running,
and will turn off 8 to 12 seconds after the
variable-speed trigger switch is released.
When the tool and/or battery pack becomes
overloaded or too hot, the internal sensors will
turn the tool off. If the tool and/or battery pack
are overloaded, the LED worklight will rapidly
flash. Rest the tool for a while or place the tool
and battery pack separately under flowing air to cool them.
The LED worklight will flash more slowly to indicate that the battery pack is at low-battery
capacity. Recharge the battery pack.
Install and Remove Bits (Fig . 9)
WARNING
if attempting to grasp the spinning chuck.
WARNING
Your tool is equipped with a keyless chuck to tighten or release bits in the chuck jaws. The
arrows on the chuck indicate the direction in which to rotate the chuck body in order to GRIP
(tighten) or OPEN (release) the chuck jaws on the bit.
a. Lock the variable-speed trigger switch "OFF" on the tool by placing the direction-of-rotation
selector in the center position.
b. Remove the battery pack and select the Drill Position.
To install the bit:
c. Rotate the chuck body counterclockwise, as viewed from chuck end, to open the chuck to
approximately the bit diameter.
d. Insert a clean bit up to the drill-bit flutes for small bits, or as far as it will go for large bits.
Close the chuck by rotating the chuck body clockwise and securely tighten by hand.
To remove the bit:
e. Rotate the chuck body clockwise, as viewed from the chuck end, to open the chuck.
f. Remove the bit.
Do not use the power of the drill while grasping chuck to loosen or
tighten the chuck jaws on the bit .
Do not use bits with damaged shanks .
Fig. 8
LED worklight
Friction burn or hand injury is possible