Tabla de contenido
Idiomas disponibles
Idiomas disponibles
5.
Drain water from air tank by opening drain valve (counter-clockwise) on
bottom of tank. NOTE: Tilt tank to drain tank completely.
tank rupture.
6.
After the water has been drained, close the drain valve (clockwise). The air
compressor can now be stored.
NOTE: If drain valve is plugged, release all air pressure. The valve can then be
removed, cleaned, then reinstalled.
Oil
Checking
1.
Set the On/Auto/Off lever to "OFF".
2.
Remove dipstick (A) and check oil on dipstick for visual signs of
contaminants (water, dirt, etc).
debris. If air vent is blocked pressure
can build in crankcase causing damage
to air compressor and possible personal
injury.
3.
Wipe oil from dipstick.
4.
Replace dipstick and allow oil to
collect on dipstick.
5.
Remove dipstick and check oil level
on dipstick, + mark indicates full
and the - mark indicates add oil. If oil
level is below - mark, slowly add oil
until it reaches the + (full) mark on the
dipstick.
NOTE: Use an oil specifically formulated for use in an air compressor, such as
Porter-Cable PAS1 air compressor oil. Oil may be found at the store where the
air compressor was purchased.
6.
Replace dipstick (A).
Changing
1.
Set the On/Auto/Off lever to "OFF".
2.
Remove the dipstick (A).
3.
Remove the oil drain plug (B) and drain oil into a suitable container.
A16759
Water will condense in the air tank. If not drained, water
will corrode and weaken the air tank causing a risk of air
Drain tank to release air pressure before removing the
dipstick or oil drain plug.
Compressor head and cylinder sleeve are very hot. Do not
touch.
Make sure air vent (C)
in dipstick is free from
B
18- ENG
C
A
(+)Full
(-)Add
Tabla de contenido
