Dremel 7300-PGT Instrucciones De Funcionamiento Y Seguridad página 31

2610046266_7300-PGT 3/21/17 10:18 AM Page 31
Replacing Screw Mandrel Accessories
Mandrel No. 401 is used with the felt polishing tip
and wheels. Thread the tip on to the screw carefully.
Mandrel No. 402 has a small screw at its tip, and is
used with emery cutting wheels and sanding discs.
To replace a band on the Drum Sander, loosen the
screw without removing it to contract the drum then
slide the old band off. Slide the new sanding band on and
then expand the drum by tightening the screw once
again.
The felt tip must thread down straight on the screw
Mandrel, and be turned all the way to the collar.
Higher speeds, usually maximum, are best for most
work, including cutting steel. Which is shown here.
Before each use, check to
make certain that all compo-
nents are assembled to accessory shank and that the
drum is sufficiently expanded to secure the band dur-
ing use. If sanding band is loose on the drum during
operation it may "fly" off and strike you or bystanders.
31