Honeywell HW6200 Manual Del Propietário página 13

Step 1: Install Support Legs
To install support legs, you will need:
‰ 25 mm full-thread hex bolts (2)
‰ 5/16" washers (2)
‰ 13 mm flange serrated nuts (6)
‰ 16 mm full-thread hex bolts (4)
‰ Socket wrench with 10 mm socket
‰ Brackets (2)
‰ Rubber stopper (2)
* Not included
CAUTION
Generator must be empty of engine oil and fuel.
Drain engine oil and fuel, if necessary.
Generator is heavy! Lifting generator can cause
back or other bodily injury. NEVER lift generator
without assistance.
Place the generator on a flat, level surface.
1.
Stand at side of generator opposite recoil starter
2.
handle. Grip frame; carefully pull up and push to tilt
generator backward.
FIGURE 6: Tip onto Generator Recoil Side
Gently set generator onto the recoil side.
3.
Place 5/16" washer in the center of each rubber stop-
4.
per.
HW6200/HW6200L Portable Electrical Generator Owner's Manual
5. Attach a rubber stopper to the bottom of each support
leg using a 25 mm full-thread hex bolt and a 13 mm
flange serrated nut; tighten until securely seated.
*
6. Attach each support leg to pre-drilled holes on bottom
of generator frame, using 16 mm full-thread hex bolts
and 13 mm flange serrated nuts; tighten until securely
seated.
FIGURE 7: Rubber Stopper Attachment to Support Leg
FIGURE 8: Support Leg Attachment to Generator
www.honeywellgenerators.com
Assembly
7