GE GFW490 Manual Del Propietario E Instrucciones De Instalación página 28

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Before you call for service...
Problem
Water does not
Automatic self system checks
enter washer or
enters slowly
Water supply is turned off
Water valve screens are
stopped up
Wrinkling
Improper sorting
Overloading
Incorrect wash cycle
Repeated washing in water
that is too hot
Grayed or
Not enough detergent
yellowed clothes
Not using HE (high efficiency)
detergent
Hard water
Water is not hot enough
Detergent is not dissolving
Dye transfer
Colored spots
Incorrect use of fabric softener
Dye transfer
Water
Water supply is improperly
temperature is
connected
incorrect
House water heater is not set
properly
Bad odor inside
Washer unused for a long time,
your Washer
not using recommended quality
of HE detergent or used too
much detergent
28
Possible Cause
• After Start is pressed, the washer does several system checks. Water
will flow 60 seconds after Start is pressed.
• Turn on both hot and cold faucets fully.
• Turn off the water source and remove the water connection hoses
from the upper back of the washer. Use a brush or toothpick to clean
the screens in the machine. Reconnect the hoses and turn the water
back on.
• Avoid mixing heavy items (like work clothes) with light items (like
blouses).
• Load your washer so clothes have enough room to move freely.
• Match cycle selection to the type of fabric you arewashing (especially
for easy care loads).
• Wash in warm or cold water.
• Use correct amount of detergent.
• Use only HE detergent.
• Use hottest water safe for fabric.
• Use a water conditioner like Calgon brand or install a water softener.
• Make sure water heater is delivering water at 120°–140°F (48°–60°C).
• Try a liquid HE detergent.
• Sort clothes by color. If fabric label states wash separately, unstable
dyes may be indicated.
• Check fabric softener package for instructions and follow directions
for using dispenser.
• Sort whites or lightly colored items from dark colors.
• Promptly remove wash load from washer.
• Make sure hoses are connected to correct faucets.
• Make sure house water heater is delivering water at 120°–140°F
(48°–60°C).
• Run a Tub Clean cycle.
• In case of strong odor, you may need to run the Tub Clean cycle more
than once.
• Use only the amount of detergent recommended on the detergent
container.
• Use only HE (high efficiency) detergent.
• Always remove wet items from the washer promptly after machine
stops running.
• Leave the door slightly open for the water to air dry. Close supervision
is necessary if this appliance is used by or near children. Do not allow
children to play on or in this or any other appliance.
What To Do
Tabla de contenido
loading

Tabla de contenido