Tabla de contenido
Idiomas disponibles
Idiomas disponibles
1
Do not make any cutouts until you have decided whether this installation will be ducted or
non-duct and then plan accordingly.
Put a thick, protective covering over cooktop,
set-in range or countertop to protect from
damage or dirt.
Determine and clearly mark with a pencil on the
ceiling where the rangehood will be installed.
A template 21 for mounting the support is
supplied in the carton with the support. Use
this template to mark holes for
support on the ceiling.
Determine and make necessary cuts for the
ductwork. The duct opening is shown on the
mounting template. Install
ductwork before mounting the hood.
21
1
"
Ø 10 mm
1/4
x4
!
WARNING
DUE TO THE SIZE AND
WEIGHT OF THIS RANGE-
HOOD, THE SUPPORT MUST
BE FIRMLY ATTACHED TO
THE CEILING. For plaster or
sheet rock ceiling, the support
must be attached to the joists.
If this is not possible, a support
structure must be built behind
the plaster or sheet rock. The
manufacturer assumes no re-
sponsibility forinjury or damage
caused by improper installa-
tions.
Determine the proper location for the Power
Supply Cable as indicated on the template.
Use a 1
" Drill Bit to make this hole. Run
1/4
the Power Supply Cable. Use caulking to seal
around the hole.
A knockout for threading through the Power
Supply from the ceiling is located on the top
of the frame. Do not connect the Power Cable
to the Wiring Box or power up the hood at this
time. Run enough power cable from the ceiling
to reach the wiring box on the hood.
8
Tabla de contenido
