Connecting The Monitor And Turning The Monitor On And Off; Connecting The Monitor To A Computer - Sharp LL-T1815 Manual De Funcionamiento

Connecting the monitor and turning the monitor on and off

CAUTION!
- When connecting, ensure that both the monitor
and computer are switched off.
- Be careful not to overly bend the cable or add
extension cords as this could lead to a
malfunction.
Cable storage
If necessary, excess cable can be housed in the
stand.
1.Remove the cover.
Gently pull the top of the cover towards yourself.
2.Run cable along the back of the stand.
Pass cable in front of the stand, and then bring it
through the back.
- If the display is to be rotated, first house the
cables with the display in the long height
position, so there is sufficient length when the
display is turned.
3.Refit the cover.
Be careful not to pinch the cable.
- If the cover is hard to refit, do not force it.
Check whether cables are trapped.
CAUTION!
- If the display is to be rotated, first house the
cable, and then check while gently turning the
display. If it cannot be turned, rehouse the cable
with sufficient slack. (If there is insufficient cable
length, rotation will be impossible. Forcing
rotation may cause cable disconnection.)

Connecting the monitor to a computer

Connecting using accessory analog signal
cable
Connect the accessory analog signal cable to the
analog RGB input terminal of the display, and the
analog RGB output terminal of the computer.
Analog signal cable
- Paying attention to connector direction, firmly
insert the signal cable to terminal, and then
tighten the screws at both sides.
11
Analog RGB input
terminal
Analog RGB output
terminal