Connecting The Monitor And Turning The Monitor On And Off; Connecting The Monitor To A Computer; Connecting The Monitor To A Power Source - Sharp LL-173C Manual De Funcionamiento

Connecting the monitor and turning the monitor on and off

CAUTION!
- When connecting, ensure that both the monitor
and computer are switched off.
- Be careful not to over bend the cable or add
extension cords as this could lead to a
malfunction.

Connecting the monitor to a computer

Connect the supplied analog signal cable to the
analog RGB output terminal of the computer.
Analog signal cable
(supplied)
- Paying attention to connector direction, firmly
insert the signal cable vertically into the
connector, and then tighten the screws at both
sides.
If connecting to a D-sub 15 pin 2 row Apple Power
Macintosh, attach a Macintosh conversion adapter
(commercially available) to the analog signal
cable.
Computer
Macintosh conversion adapter
Note:
- If connecting to the Sun Ultra series, a
conversion adapter (commercially available)
may be required.
Analog RGB terminal (Mini D-sub 15 pin, 3 rows)
Computer
Connecting the monitor to a power
source
Power cord
(supplied)
13
Power terminal
AC outlet