Connecting The Monitor And Turning The Monitor On And Off; Securing The Cables [Ll-172G]; Connecting The Monitor To A Computer - Sharp LL-172A Manual De Funcionamiento

Connecting the monitor and turning the monitor on and off

CAUTION!
- When connecting, ensure that both the monitor
and computer are switched off.
- Be careful not to over bend the cable or add
extension cords as this could lead to a
malfunction.
Securing the cables
Use the supplied cable clamps to secure the
cables connected to the terminals.
The upper and lower cable clamps have different
shapes. Check the shapes of the clamps before
attaching them to the stand.
CAUTION!
- When adjusting the viewing angle, cables may
be pulled. Therefore, ensure that the cables
have sufficient slack.
Orient the side of the clamp
with the protrusion to the
stand and attach the clamp.
[LL-172G]
14

Connecting the monitor to a computer

Analog connection [LL-172A]
Connect the accessory analog signal cable to the
analog RGB output terminal of the computer.
Analog signal cable
- Paying attention to connector direction, firmly
insert the signal cable vertically into the
connector, and then tighten the screws at both
sides.
Analog RGB terminal
(Mini D-sub 15 pin, 3 row)