Important; Install Custom Overlay Panel - Kitchen Aid 2300275B Manual De Uso

Clean Before Using
After you remove all of the package materials, clean the inside of
your refrigerator before using it. See the cleaning instructions in
"Refrigerator Care."
Important information to know about glass shelves
and covers:
Do not clean glass shelves or covers with warm water when
they are cold. Shelves and covers may break if exposed to
sudden temperature changes or impact, such as bumping.
For your protection, tempered glass is designed to shatter
into many small, pebble-size pieces. This is normal. Glass
shelves and covers are heavy. Use special care when
removing them to avoid impact from dropping.

Install Custom Overlay Panel

IMPORTANT:

Create custom overlay panel according to the specifications
in the "Custom Overlay Panel" section.
KitchenAid is not responsible for the removal or addition of
molding or decorative panels that would not allow access to
the refrigerator for service.
Remove the Door
IMPORTANT: Do not remove the grease from the washer, top
spacer or top hinge pin. Be sure to set aside the top hinge, top
spacer and washer for later use.
1. Using a Phillips screwdriver, remove the three screws from
the top hinge. Remove the top hinge.
A. Screws (3)
B. Top hinge
C. Washer
D. Top spacer
E. Door
2. Remove the three screws from the top spacer. Remove the
top spacer and washer.
6
3. Open the door. Lift the front of the door up, pulling straight
out to remove as shown.
Attach the Overlay Panel
NOTE: If the overlay hooks are not installed, see "Custom
Overlay Panel" for overlay hook locations.
1. Position the overlay panel ¹⁄₂" (1.27 cm) higher than the door.
Be sure to position the overlay hooks to the pilot holes.
A
B
C
2. Insert the overlay hooks into the top of the holes in the door.
Push against the overlay panel to force the overlay hooks
D
deeper into the door. Pull the overlay panel straight down to
secure the overlay hooks to the door.
3. Using a Phillips screwdriver, attach the overlay plates to the
bottom of the overlay panel and door as shown.
E
A B C D
A. Overlay panel
B. Door
C. Overlay plates (2)
D. Round-head screws (8)