Charging Procedure; Technical Data - Worx WA3765 Manual Original

1. BATTERY PACK *
2. CHARGER
3. CHARGE INDICATOR LIGHT
* Not all the accessories illustrated or de-
scribed are included in standard delivery.
We recommend that you purchase your accessories
listed in the above list from the same store that sold
you the battery charger. Use of any other accessory
or attachment may increase the risk of injury. Refer
to the accessory packaging for further details. Store
personnel can assist you and offer advice.

TECHNICAL DATA

Rated input voltage
Output voltage
Charging current
Rated input power
Charge battery
Charging time (approx.)
Battery pack
6
Machine weight
For the technical data of the types, the number of
cells and the rated capacity of the batteries that
can be charged, please refer the nameplate of the
battery pack supplied by WORX.
Vehicle Charger
11V~26V
20V
2.0Ah
60min
4.0Ah
120min

CHARGING PROCEDURE

NOTE: Before using the tool, read the
instruction book carefully.
CHARGING INSTRUCTIONS
1. CHARGING YOUR BATTERY PACK
WARNING: The charger and battery pack
are specifically designed to work together
so do not attempt to use any other devices. Never
insert or allow metallic objects into your charger
or battery pack connections because an electrical
failure and hazard will occur.
2. BEFORE USING YOUR CORDLESS TOOL
Your battery pack is UNCHARGED and you must
charge once before use.
3. HOW TO CHARGE YOUR BATTERY
CHARGING PROCEDURE
1) Unwrap cord and plug in the car power supply
interface.(See Fig. A)
2) Insert the battery pack into the charger, making
2A
sure the battery pack is fully seated into the
charger. (See Fig. B)
50W
WARNING: When battery charge runs
out after continuous use or exposure
Li-Ion
to direct sunlight or heat, allow time for the
battery to cool down before re-charging to
achieve the full charge.
NOTICE: To extend the vehicles battery life,
it is recommended to only use the WA3765
charger while the vehicle is in operation
CHARGING INDICATOR
This charger is designed to detect some problems
that can arise with battery packs. Indicator lights
0.5kg
indicate problems (see table below). If this occurs,
insert a new battery pack to determine if the charger
is OK. If the new battery charges correctly, then the
original pack is defective and should be returned
to a service center or recycling service center. If the
new battery pack displays the same problem as the
original Battery Pack, have the charger tested at an
authorized service center.
Light ON/ flash
Red on
Red flash
Green on
Green flash
- - - - - -
BATTERY TEMPERATURE PROTECTION
Status
Defective Battery
Battery Temperature Protection
The temperature of battery
- - - - -
pack is less than 0˚C or
more than 45˚C .
Fully Charged
Charging
EN