Tabla de contenido
Idiomas disponibles
Idiomas disponibles
15. When charging batteries, ensure that the
battery charger is in a well-ventilated area and
away from inflammable materials. Batteries can
get hot during charging. Do not overcharge any
batteries. Ensure that batteries and chargers are
not left unsupervised during charging.
16. Do not recharge non-rechargeable batteries, as
they can overheat and break.
17. Longer life and better performance can be
obtained if the battery pack is charged when the
air temperature is between 18
not charge the battery pack in air temperatures
below 4.5
C, or above 40.5
o
as it can prevent serious damage to the battery
pack.
18. Charge only battery pack of the same
model provided by WORX and of models
recommended by WORX.
SYMBOLS
Read the operator's manual
Warning
For indoor use only
Double insulation
Fuse
Positive terminal
Negative terminal
Waste electrical products must not be
disposed of with household waste.
Please recycle where facilities exist.
Check with your local authorities or
retailer for recycling advice.
Battery charger
C and 24
C. Do
o
o
C. This is important
o
CHARGING PROCEDURE
NOTE: Before using the tool, read the
instruction book carefully.
CHARGING INSTRUCTIONS
1. CHARGING YOUR BATTERY PACK
WARNING: The charger and battery pack are
specifically designed to work together so do
not attempt to use any other devices. Never insert
or allow metallic objects into your charger or battery
pack connections because an electrical failure and
hazard will occur.
2. BEFORE USING YOUR CORDLESS TOOL
Your battery pack is UNCHARGED and you must
charge once before use.
3. HOW TO CHARGE YOUR BATTERY
CHARGING PROCEDURE
1)
Plug the charger into an appropriate outlet.
2)
Slide the battery pack into the charger. The
LIGHT (3) will become green and flash to show
charging has started.
3)
After charging approx 1-2 hours, the light will
stay green without flashing, which means the
battery is full, and charging is completed.
WARNING: When battery charge runs
out after continuous use or exposure
to direct sunlight or heat, allow time for the
battery to cool down before re-charging to
achieve the full charge.
CHARGING INDICATOR
This charger is designed to detect some problems
that can arise with battery packs. Indicator lights
indicate problems (see table below). If this occurs,
insert a new battery pack to determine if the charger
is OK. If the new battery charges correctly, then the
original pack is defective and should be returned
to a service center or recycling service center. If the
new battery pack displays the same problem as the
original Battery Pack, have the charger tested at an
authorized service center.
Light
ON/ Flash
Red on
Red flash
- - - - -
Status
Defective Battery
Battery Temperature
Protection
The temperature of
battery pack is less
than 0
C or more than
o
45
C.
o
EN
5
Tabla de contenido
