EGO ST1500F Manual Del Operador página 23

3. Cut one piece of cutting line 16 ft.
(5m) long. Insert the line into the
mounting hole, which is located
inside the eyelet. Push until the end
of the line comes out of the other
side of the spool base. Pull the
line from the other side until equal
amounts of line appear on both
sides of the spool (Fig. 15).
4. Press, while rotating the spool
retainer in the direction indicated by
the arrow, to wind the cutting line
onto the spool until approximately
5.5in. (14cm) of line is showing on
each side (Fig. 16).
5. Push the spool retainer down while
pulling on lines to manually advance
the line and to check for proper
assembly of the trimmer head.
RELOAD THE CUTTING LINE, IF NECESSARY
NOTICE: When the cutting line breaks from the line outlet or the cutting line is not
released when the trimmer head is tapped, you need to remove the remaining cutting
line from the spool retainer and follow the steps below to reload the line.
56-VOLT LITHIUM-ION CORDLESS 15" STRING TRIMMER
15
Mounting Hole
inside the
Eyelet
16
5.5" (14 cm)
23