Triton EPA001 Instrucciones De Uso página 7

Loosely fit a short Coach Bolt (17) and Round Knob (18) to
the Front and Rear Table Brackets (19 and 20) (Fig. 12).
Fig. 13
Fit the brackets to the nut carriers using a short M6 screw
(12) and Washer (7). Push brackets in the direction shown
to take up any movement before tightening (Fig. 13). Make
sure the round knobs face toward each other and the
notched ends of the brackets point outward.
Fig. 14
Insert the Front and Rear Pivot Brackets (21 and 22)
between the plastic and steel components of the table
brackets and push until the steel tabs and notches engage
(Fig 14). Note: these parts may be already pre-assembled.
The small plastic stops must face inward, toward each
other. Tighten the knobs.
Fit the Brace Struts (25) and Front and Rear Height
Brackets (23 and 24) to the inside face of the pivot
brackets using short M6 Screws (12), Nyloc Nuts (26) and
Washers (7) (Figs. 15 and 16). The bolts prefitted to the
height brackets locate in the slots on the pivot brackets.
Two washers are used at each end - against the nut and
inserted between the height adjustment bracket and
brace strut (Fig. 16).
Fig. 15
Fit the brace with holes in it at the end furthest away
from the table T-slots and fit both braces with the plastic
toggles facing away from the T-slots (Fig 15).
Fig. 12
Fig. 16
Turn the table over and re-fit to the Workcentre.
Ensure the table brackets are fully located and tightened.
Locate the braces with the toggles resting on the
Workcentre base channel (Fig. 17). Loosen the nuts and
adjust the toggle positions until the braces 'snap' down
into place (Fig. 17) (inset). The correct position should
support the table without lifting it. Re-tighten the nuts.
Fig. 17
Fit Round Knobs (18) to the front and rear height
adjustment brackets and lock them tilted outward slightly,
for easy mounting of the planer chassis (Fig. 18).
Fig. 18
Fig. 19
Slide the planer chassis down between the brackets
and insert a long Coach Bolt (27), as shown, through the
square tubes at each end while supporting the chassis
(Fig. 19).
Fit the Height Indicators (28) and Round Knobs (18) to the
coach bolts (Fig. 20).
GB
Assembly
7