Triton EPA001 Instrucciones De Uso página 5

e) Maintain power tools. Check for misalignment or
binding of moving parts, breakage of parts and
any other condition that may affect the power
tool's operation. If damaged, have the power tool
repaired before use. Many accidents are caused by poorly maintained power tools.
f) Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
ASSEMBLY
FITTING THE PLANER TO THE CHASSIS
Fit the Alignment Plate (1) to the lower side of the Planer
Chassis (2) (flange outward) using the M4 Screws (3) and
Flange Nuts (4). Tighten firmly with a Phillips screwdriver
(Fig. 1).
Fig. 1
Fit the Front Clamps (5) to the chassis, using the long
M6 Screws (6), Washers (7) and Hex Nuts (8) (the nuts
locate inside the clamp bases) (Fig.2). Do not tighten yet.
Most planers mount using the planers fence holes - an
exception is shown in (Fig.4).
Fig. 2
Fig. 3
Leave the clamps free to slide in their slots to match the
height of the planers fence hole.
g) Use the power tool, accessories and tool bits etc.
in accordance with these instructions, taking into
account the working conditions and the work to
be performed. Use of the power tool for operations
different from those intended could result in a
hazardous situation.
5) Service
a) Have your power tool serviced by a qualified repair
person using only identical replacement parts.
This will ensure that the safety of the power tool is
maintained.
Fig. 4
Remove the 4 perforated cardboard packers from the
carton flaps. Sit the chassis on top of the packers, as
shown, and allow the heads of the alignment plate screws
to overhang the edge of your worktable (Fig 5.).
Fig. 5
Adjust your planer to '0' (front and rear shoes in line)
and sit it flat on your assembly table with the rear shoe
touching the edge of the alignment plate. Relocate the
alignment plate to suit your planer if required.
Push and tap the plastic Wing Knobs (9) onto the
hexagonal ends of the clamp bolt. Extend the clamps, by
tightening the wing knobs until the conical ends locate
into the planer fence holes (Fig. 5) Ensure the cones
locate exactly central within the fence holes, otherwise
they will alter the planer alignment when fully tightened.
If everything appears correctly lined up, tighten the
Phillips screws holding the front clamp bases. Then
tighten the cones into the fence holes ensuring the rear
planer shoe remains in full contact with the edge of the
plate. DO NOT OVERTIGHTEN.
Safety Instructions / Assembly
GB
5