Kränzle K 1050 TS T Manual De Instrucciones página 20

Functional details
Water and cleaning / care products system
Water can be connected at mains pressure to the high pressure pump. The water is
then forced under pressure by the high pressure pump to the lance. The high pressu-
re jet is formed by the nozzle at the end of the lance.
Environmental, refuse disposal and water protection regulations must
be observed!
Lance with trigger gun with safety catch
The machine can only be operated when the trigger of the trigger gun with safety
catch is pulled. When the trigger is pulled, the trigger gun opens. The liquid is then
pumped to the nozzle. The spray pressure increases and quickly reaches the selec-
ted operating pressure. When the trigger is released, the trigger gun closes and any
further spraying of liquid from the lance is stopped. The pressure thrust serves to clo-
se the start/stop system, thus causing interruption of the energy supply to the motor.
Owing to this innovative system the high pressure hose is relieved and enables higher
durability of the hose. Opening the gun causes the start/stop system to open, the
electric motor is automatically restarted and the pump starts to transfer the water
on to the high pressure jet where the cleaning jet is generated.
The trigger gun with safety catch is a safety device. Repairs should
only be performed by qualified persons. Should replacement parts be
required, use only components authorized by the manufacturer.
Replacements, repairs, new adjustments and sealing should only be
performed by qualified persons.
Prior to putting the machine into operation make sure that all safety
instructions be observed.
38
Functional details
Motor overload protection
The motor is protected against overloading by means of an overload protection de-
vice included in the motor coil. In the event of overloading or jamming, the excess
temperature cut-out serves to switch off the motor. In case of repeated switching
off the motor by means of the excess temperature cut-out, make sure to eliminate
the cause of the failure.
Replacements and inspection work should only be performed by quali-
fied persons when the machine is disconnected from the power supply,
i.e. with plug pulled out from the electrical socket.
High pressure hose and spray device
The high pressure hose and spray device which are part of the K 1050 TS T equipment,
are made of high quality material and engineered to conform with the operating con-
ditions of the high pressure cleaner and are duly labeled.
If replacement parts are required, only such parts that are authorized
by the manufacturer may be used. The warranty is automatically void
if spare parts of third-party providers are used! The high pressure hose
and spray device must be connected in a pressure-tight manner (without
leakage).
The high pressure hose may not be driven over, pulled excessively, or
twisted. The hose may under no circumstances be pulled over sharp edges.
Defective high pressure hoses must not be repaired (acc. to DIN 20022) but
have to be replaced by new hoses approved by the manufacturer.
GB
39