General Rules; Safety Precautions - Kränzle K 1050 TS T Manual De Instrucciones

Ocultar thumbs Ver también para K 1050 TS T:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

General rules

Range of application
Use machine for cleaning tasks with high pressure water jet and detergents or with
high pressure water jet without detergents only.
The high pressure cleaner is designed for use in private environment only.
Environmental, refuse disposal and water protection regulations must
be observed!
Inspections
The machine must be inspected according to the "Guidelines for Liquid Spray
Devices" at least once every 12 months by a qualified person, to ensure that
continued safe operation is guaranteed. The results of the inspection are to be
recorded in writing. This may be done in any form.
High pressure cleaners used for commercial purposes have to be checked
by a qualified person at least every 12 months!
Accident prevention
The machine is designed for accidents to be impossible if used correctly. The
operator is to be notified of the risk of injury from hot machine parts and the
high pressure water jet. The "Guidelines for Liquid Spray Devices"
plied with.
Oil leakage
If oil leaks contact your nearest after-sales service (dealer) at once.
Failure to observe this instruction may cause damage to the environment
and/or transmission gearbox.
32

Safety precautions

Persons operating the machine should wear the necessary protective clothing, i.e.
waterproof clothing, rubber boots, safety goggles, headwear etc. It is prohibited
to use the machine in close vicinity to people lacking suitable protective clothing!
Do not spray against matter containing asbestos or other hazardous substances!
Never spray liquids containing solvents like varnish solvents, petrol, oil or similar
liquid!
Due to the high pressure jet, damage may occur on the objects to be cleaned, e.g.
car tires; therefore, a minimum distance of 30 cm is to be kept.
Prior to putting the high pressure cleaners into operation, check its components
(HP hose, power supply cables, safety trigger gun) for any damage. Replace de-
fect or damaged components!
The high pressure cleaner is to be properly used. The user is required to adhere to
local requirements and to watch out for any persons in the danger zone!
must be com-
When using high pressure water for
cleaning, make sure that there is a clearly
noticeable recoil effect on the lance.
Therefore ensure a firm footing (see
chapter „Technical Data")
Apply the safety catch on the spray gun
after each use in order to prevent
unintentional spraying!
GB
33
Tabla de contenido
loading

Tabla de contenido