Quick Installation - Tripp-Lite SmartPro SLT Manual Del Propietário

201111068 93-3154.qxd

Quick Installation

1
With the UPS disconnected from
utility power, use a small tool to set
the Voltage Dip Switch to match your
input voltage. (All models are preset
to the 120V setting.)
2
Plug the UPS into an outlet on a
dedicated circuit.
NOTE! after you plug the UPS into a live AC
outlet, the UPS will automatically charge its
batteries,* but will not supply power to its outlets
until it is turned ON.
* The BATTERY CHARGE LED will be the only LED illuminated
3
Plug your equipment into the UPS.
Models SMART1500SLT & SMART1050SLT:
All outlets provide battery backup and surge
protection for computers, monitors and other
critical devices. Model SMART750SLT: Select
outlets provide battery backup and surge
protection for computers, monitors and other
critical devices; select outlets provide surge
protection only for printers and other nonessential
devices.
Do not plug high-draw equipment such as laser
printers into
protection outlets.
Note: Your UPS is designed to support electronic equipment only.
You will overload the UPS if the total VA rating for all equipment
connected through the battery backup/surge protection outlets
exceeds the UPS's Output Capacity. To find your equipment's VA
ratings, look on their nameplates. If the equipment is listed in
amps, multiply the number of amps by 120 to determine VA.
(Example: 1 amp × 120 = 120 VA). If you are unsure if you have
overloaded the UPS's outlets, see "OUTPUT LOAD LEVEL"
LED description.
4
Turn the UPS ON.
Press and hold the "STANDBY" button for one
second. The alarm will beep once briefly after one
second has passed. Release the button.
11/4/2011 2:55 PM Page 3
the battery backup/surge
3
1
2
3
4