Technical Characteristics - V2 CU4 Manual Del Usuario

m
IMPORTANT REMARKS
• Attention: for people safety it is important to follow carefully
the instructions. Keep the instructions.
• Important safety instructions for the installation. Attention: a
wrong installation can cause serious accidents. Follow carefully
the installation instructions.
• This device can be installed only from qualified persons and
can be used only inside a tubular motor.
• As regards insulation, the features of push buttons must be
suitable for electrical installations (230VAC / 120VAC).
• In order to protect the device, the installer must provide for
a magnetotermical differential switch (separation among the
contacts: at least 3 mm), ensuring the omnipolar sectioning
from the power supply.
• In case of damages due to incorrect installation, the wiring
provided together with this device can be replaced only by the
manufacturer or a qualified person.
• For correct insertion of the (optional) radio receiver, please
refer to the figure shown on the electrical connections page.
EU DECLARATION OF CONFORMITY
V2 S.p.A. hereby declare that CU4 products conform to the
essential requirements established in the following directives:
• 2014/30/UE (EMC Directive)
• 2014/35/UE (Low Voltage Directive)
• 2014/53/UE (Radio Directive)
• ROHS2 2011/65/CE
Racconigi, lì 01/06/2016
V2 S.p.A. legal representative.
Giuseppe Pezzetto
DESCRIPTION
The unit can control two 230 VAC asynchronous motors used in
systems for screens or shades.
The motors can be operated by means of push buttons connected
to the terminal board, or by means of transmitters.
Main features:
• Plug-in 434.15 MHz radio receiver (OPTIONAL cod. 11B037),
compatible with PROTEO / DUO / ADLER / DEV-T1 range
transmitters.
• The ability to memorise up to 38 transmitters.
• The WIND, SUN and TEMPERATURE sensor levels can be
adjusted using a transmitter or the LEDs mounted on the card.
• Input for WIND / MISTRAL / METEO / HURRICANE sensors.
• Independent inputs for each motor for man-present
UP/DOWN buttons or OPEN/STOP/CLOSE/STOP button.
• Outputs for two motors, controlled either independently (each
motor with its own limit switch) or synchronised using just the
limit switch of motor 1. In the latter case, can be used only
motors with mechanical limit switches and without on board
control unit.
• Dip switches for setting the main functions.
• Input for sun sensor ON/OFF.

TECHNICAL CHARACTERISTICS:

Power supply: 230 VAC -50 Hz
Max. motor power: 500 W
Fuse rating: 5 A
Protection level: IP55
Working temperature: 20 ÷ +60 °C
DESCRIPTION OF THE PUSH BUTTONS
AND LEDS
The card has 4 push buttons + 10 LEDs:
1 push button key for selecting the motor (MOT)
1 push button key for selecting the sensor (SENS)
2 push button keys for selecting the sensor level (+ and -)
2 LEDs for displaying motor status (MOT1 and MOT2)
4 LEDS for displaying sensor status (WIND, SUN, RAIN, TEMP)
5 LEDS for displaying sensor levels (1, 2, 3, 4, 5)
MOT key: this is used to select the motor to be programmed.
SENS key: this is used to select the sensor for the levels to be
altered
The - button: this allows reducing the sensor level
The + key: this allows raising the sensor level
WORKING TIME OF MOTOR
The control unit stops the motor movement after 2 minutes: in
case of limit switches malfunction this "time out" avoids the
motor overheating.
- 17 -