Electric Connections - Saivod LV8 DIGITAL Manual De Uso Y Manutención

5.3 CONNECTION OF DRAINAGE WATER
The curved end of drainage tube T, which is being supplied with your appliance, should be hooked
onto the edge of a sink or into a drainage pipe.
A special siphon should be used to prevent bad odours.
During the assembly, the following precautions should be taken:
- the drainage tube must not be bent to avoid blockages;
- the tube's end, relative to the top surface of the dishwasher (fig. 4), must be placed at a height
between 32 and 80 cm;
- the end of the tube must never be immersed in water;
- the drainage tube must not be extended to more than a maximum length of 1 metre. The extension
must have the same internal diameter. Furthermore, the maximum height at which the tube's end
can be placed (in the case of an extended tube) must be reduced from 80 to 50 cm.
- If you use a drainage pipe, make sure its internal diameter is not inferior to 4 cm.

5.4 ELECTRIC CONNECTIONS

The appliance may only be connected to a properly installed electric outlet with
an earth (ground) contact. The connection must be carried out in correspondence
with existing laws and regulations and supplementary rules issued by the supplier
of electric power.
The tension shown on the data tag must correspond to the power tension of the electric
grid at the site of installation.
See data tag for the size and format of the electric outlet to be used.
T
T
4
1 2 3 4 5 6 7 8 9 0 1
5
1 2 3 4 5 6 7 8 9 0 1
1 2 3 4 5 6 7 8 9 0 1
GB
1 2 3 4 5 6 7 8 9 0 1
1 2 3 4 5 6 7 8 9 0 1
1 2 3 4 5 6 7 8 9 0 1