Heath Zenith 7868 Manual De Instrucciones página 3

Inside Push Button
Tune Setting Table
Push Button
Jumper - ON
Jumper - OFF
1. PROBLEM: Chime does not sound.
A. POSSIBLE CAUSE: Batteries not installed correctly.
A. CORRECTIVE ACTION: Make sure batteries are installed according to
the diagram inside the push button and chime.
B. POSSIBLE CAUSE: Batteries are dead.
B. CORRECTIVE ACTION: Check charge of push button and chime bat-
teries and replace if necessary.
C. POSSIBLE CAUSE: Push button and chime are not synced.
C. CORRECTIVE ACTION: Sync the push button and chime.
• Press and hold the button on the chime until the chime sounds a
"Beep-Beep".
• Press the push button within 30 seconds. The chime will sound a
"Beep-Beep" tone to indicate the push button is synced.
• Press the push button to ensure operation.
Helpful Videos – www.hzsupport.com
Tune Settings
The chime has different selectable tunes: Ding
(one note tune) or Ding-Dong (two note tune).
The factory setting is for the Ding-Dong tune. This
tune can be changed by following the instructions
in the Tune Setting Table.
Note: All chime models are designed to work with
up to 5 push buttons (sold separately). All chimes
are designed to play only two different tunes no
matter how many push buttons are used.
Tune
Ding
Ding-Dong
Troubleshooting
Helpful Answers – 1-800-858-8501
3