Tabla de contenido
Idiomas disponibles
Idiomas disponibles
4. MOVING THE MACHINE
This machine is fitted with castors to make it easier to move. Take care
when moving the machine on an inclined surface.
The overall height of the machine is 1860mm. Take care of any overhead
obstructions. (e.g. Light Fittings, Electric Cables etc.)
5. INSTALLATION
Notes on Installation
ENSURE THAT THE MACHINE IS LEVEL AND STABLE BY
RAISING AND ADJUSTING THE LEVEL ADJUSTERS.
FAILURE TO COMPLY MAY CAUSE THE BALL TO NOT SPIN
CORRECTLY OR THE TILT SWITCH TO MALFUNCTION.
WARNING
CAUTION
NOTE
(See Section 5-1 Page 32)
•
N E V E R t u r n t h e p o w e r t o t h e m a c h i n e O N u n t i l
installation has been completed.
•
In order to prevent possible electric shocks, be sure
that the machine is connected to the mains with a
securely connected earthed plug.
•
So that customers are not injured , ensure that there is
at least 500mm separation between other machines or
walls and 1700mm clearance in front of the machine.
•
In order to avoid damage to the machine due to mis-
operation, ensure that the voltage of the mains supply is
230volts AC.
•
If the location site of this machine has a polished floor it is
recommended that rubber pads are fitted under the level
adjusters to prevent the machine sliding on the floor.
•
In order to gain access to the Power Supply and CPU
assemblies, make sure that the rear of the machine is
separated from a wall or other machine by at least 500mm.
Page 28
Tabla de contenido
