Securing The Wheelchair To The Vehicle - Quickie QRI Manual De Instrucciones

Q R I
E. SECURING THE WHEELCHAIR TO THE
VEHICLE
This wheelchair must be in a forward facing position
during travel in a motor vehicle. The recommended
clear zones for wheelchair seated occupants restrained
by both pelvic and upper-torso belt(s) and only by a
pelvic belt are shown in the diagrams and described
below. Frontal Clear Zones (FCZ) need to be larger
when upper-torso belt(s) are not used.
The rear clear zone of 16-inches is measured from the rearmost
point on an occupant's head.
The frontal clear zone is measured from the front most point on an
occupant's head and is 26-inches with pelvic and upper-torso
belt(s) and 37-inches with only a pelvic belt.
The frontal clear zone may not be achievable for wheelchair-seated
drivers.
The estimated seated height (HHT) from the ground or floor to
the top of the wheelchair-seated occupant's head ranges from
approximately 47-inches for a small adult female to about 61- inch-
es for a tall adult male.
Top View
Side View
122143 Rev. C
WARNING
frontal clear zone
SECUREMENT POINTS
Front
securement
point
Indicates wheelchair securement points which conform
to ANSI/RESNA WC/Vol. 4, Section 19/ISO 7176-19.
This wheelchair is to be used only with Wheelchair Tie-down and
Occupant Restraint Systems (WTORS) that have been installed in
accordance with the manufacturer's instructions and SAE J2249.
NOTE: A copy of SAE J2249 Wheelchair Tie-down and Occupant Restraint
Systems (WTORS) for use in Motor Vehicles can be obtained from:
SAE International, 400 Commonwealth Drive,Warrendale, PA
15096-0001. (877) 606-7232 or (724) 776-4970
Attach WTORS to the tie-down brackets in accordance with the
manufacturers instructions and SAE J2249.
SECURING THE OCCUPANT-WHEELCHAIR-
ANCHORED BELTS
NOTE– Belt is not included.
Only use a pelvic belt system that meets the require-
ments of ANSI/RESNA W/C 19 and SAE J2249.
1. Install the pelvic belt pin (B)
onto the pelvic belt secure-
ment point anchored to the
seating frame (A) of the
Quickie QRi. Use a 5mm
Allen head wrench and
torque to144 in-lbs when
attaching the pelvic belt to
the mounting anchor (C).
Pelvic belt bolt and nut are
provided with transit brack-
ets.
2. Repeat Step 1 for the oppo-
site side.
14
IX. WARNINGS: TRANSIT
Rear securement point
WARNING
A
B
C