Troubleshooting - Zanussi ZWT 71401 WA Manual De Instrucciones

2. Close the water tap.
3. Place the end of the emergency emptying hose
and that of the inlet hose in a bowl placed on
the floor and let water flow out of the hoses.
4. Set the Drain programme and let it operate until
the end of the cycle.
5. Turn the programme knob to
the appliance from the power supply.
6. Screw the water inlet hose back on and re-fit
the emergency emptying hose after having put
the cap on again.
WARNING! Make sure that the
temperature is more than 0 °C before
you use the appliance again.
The manufacturer is not responsible
for damages caused by low
temperatures.
EMERGENCY EMPTYING OUT
If the appliance does not drain the water, proceed
as follows:

TROUBLESHOOTING

WARNING! Refer to Safety chapters.
INTRODUCTION
The appliance does not start or it stops during
operation.
First try to find a solution to the problem (refer to
the table). If the problem persists, contact the
Authorised Service Centre.
With some problems, the acoustic signals
operate and the display shows an alarm
code:
• - The appliance does not fill with water
properly.
POSSIBLE FAILURES
Problem
The programme does not
start.
1. Disconnect the mains plug from the mains
2. Close the water tap.
3. If necessary, wait until the water has cooled
4. Place a bowl on the floor and put the end of
to disconnect
The water should drain by gravity into the bowl.
5. When the bowl is full, put the cap back on the
6. Empty the bowl. Repeat the procedure until
7. Clean the pump if necessary as previously
8. Replace the emergency emptying hose in its
9. Screw the water inlet hose back on.
•
•
•
•
• Make sure that the mains plug is connected to the mains socket.
• Make sure that the appliance door is closed.
• Make sure that there is not a damaged fuse in the fuse box.
• Make sure that the Start/Pause has been pressed.
• Deactivate the Child Lock function if it is on (if available).
socket.
down.
the emergency emptying hose into the bowl.
Remove its cap.
emergency hose.
water stops flowing out.
described.
seat after having plugged it.
- The appliance does not drain the water.
- The appliance door is open or not
closed correctly. Please check the door!
- The mains supply is unstable. Wait until
the mains supply is stable.
- No communication between electronic
elements of the appliance. Switch off and
switch on again.
WARNING! Deactivate the appliance
before you do the checks.
Possible solution
19