Water Drainage; Preparation And Assembly Of The Door - Zanussi ZWT 71401 WA Manual De Instrucciones

WATER DRAINAGE

The end of the drain hose can be positioned in
three ways:
• Hooked over the edge of a sink using the
plastic hose guide supplied with the
machine.
In this case, make sure the end cannot come
unhooked when the appliance is emptying. This
BUILDING IN
OVERVIEW
This appliance has been designed to be built into
the kitchen furniture. The recess should have the
dimensions shown in the picture below:
600 mm
min.
560 mm
min.
820 mm
75 mm
60 mm
596 mm
555 mm
818 mm
170 mm
100 mm
could be done by tying it to the tap with a piece
of string or attaching it to the wall.
• In a sink drain pipe branch.
This branch must be above the trap so that the
bend is at least 60 cm above the ground.
• Directly into a drain pipe at a height of not
less than 60 cm and not more than 90 cm.
The end of the drain hose must always be
ventilated, i.e. the inside diameter of the
drainpipe must be larger than the outside
diameter of the drain hose. The drain hose must
not be kinked.
The drain hose may be extended to a maximum of 4
metres. An additional drain hose and joining piece
is available from your local Service Centre
We recommend that you keep the
packaging and the transit bolts for any
movement of the appliance.
PREPARATION AND ASSEMBLY OF THE
DOOR
The appliance is originally prearranged for the
assembly of a door opening from right to left (see
picture below)
23