Working With The Diamond Saw Blade In Fibre Cement Board (Special Accessories); Working With Guide Rails; Working With The Position Indicator Mt-Pa; Service And Maintenance - Mafell MT55 18M bl Traducción Del Manual De Instrucciones Original


Fasten the guide rail on the workpiece.

Tilt the locking lever 20 (Fig. 2) clockwise up to
the limit stop. The scoring depth is now set to
approx. 3 mm (1/8 in.).

Place the machine with the guide groove onto
the guide rail.

Set the cutting depth - take into account the
guide rail thickness (see Chapter 5.3).

Score the board. Tilt the locking lever 20 (Fig. 2)
counter clockwise up to the limit stop.

Plunge to the preset cutting depth and saw the
full board thickness.
5.9 Working with the diamond saw blade in fibre
cement board (special accessories)
Proceed as follows:

Use a suitable saw blade (see Chapter 4.5).

Exchange the saw blade (see Chapter 4.6).
The diamond saw blade was
developed for fibre cement board.
The diamond-fitted teeth are more
delicate than the teeth of the HM
saw blade. This is why you are
working with a guide rail.

5.10 Working with guide rails


To achieve more accurate guidance, set the
guide clearance with the two setting wheels 21
(Fig. 4).
The plunge cut saw can be used to work with the
guide rails that are available as special accessories.
In addition, it is possible to use some rails that are
freely available on the market.

To do so, unscrew the screws and remove the
insert 24 (Fig. 2).

5.11 Working with the position indicator MT-PA

For pictograms in this regard see page 4.
6

Service and maintenance

Danger
Unplug the rechargeable battery for
all service work.
MAFELL machines are designed to be low in
maintenance.
The ball bearings used are greased for life. When the
machine has been in operation for a longer period of
time, we recommend to hand the machine in at an
authorised MAFELL customer service shop for
inspection.
Only use our special grease, order No. 049040 (1 kg
tin) for all greasing points.

6.1 Storage

If the machine is not used for a longer period of time,
it has to be carefully cleaned. Spray bright metal parts
with a rust inhibitor.

6.2 Transport

The contained lithium-ion batteries are subject to the
Dangerous Goods Legislation requirements. The user
can transport the batteries by road without further
requirements.
When being transported by third parties (e.g.: air
transport or forwarding agency), special requirements
on packaging and labelling must be observed. For
preparation of the item being shipped, consulting an
expert for hazardous material is required.
Dispatch batteries only when the housing is
undamaged. Tape or mask off open contacts and
pack up the battery in such a manner that it cannot
move around in the packaging.
Please also observe possibly more detailed national
regulations.

6.3 Disposal of rechargeable batteries/batteries

The machine, rechargeable
batteries, accessories and
packaging should be sorted for
environmental-friendly recycling.
Do not dispose
batteries/rechargeable
waste!
Only for EC countries:
-28-
of power tools
batteries into household
and