Using The Lcd Screen Correctly; Specifications - Pioneer AVH-X5850BT Manual De Instrucciones

Appendix

Using the LCD screen correctly

Handling the LCD screen

When the LCD screen is subjected to direct sunlight for
a long period of time, it will become very hot, resulting in
possible damage to the LCD screen. When not using this
product, avoid exposing it to direct sunlight as much as
possible.

The LCD screen should be used within the temperature
ranges shown in Specifications on page 63.
 Do not use the LCD screen at temperatures higher or lower
than the operating temperature range, because the LCD
screen may not operate normally and could be damaged.

The LCD screen is exposed in order to increase its visibility
within the vehicle. Please do not press strongly on it as this
may damage it.
 Do not push the LCD screen with excessive force as this may
scratch it.
 Never touch the LCD screen with anything besidess your
finger when operating the touch panel functions. The LCD
screen can scratch easily.
Liquid crystal display (LCD) screen
 If the LCD screen is near the vent of an air conditioner, make
sure that air from the air conditioner is not blowing on it.
Heat from the heater may break the LCD screen, and cool
air from the cooler may cause moisture to form inside this
product, resulting in possible damage.
 Small black dots or white dots (bright dots) may appear on
the LCD screen. These are due to the characteristics of the
LCD screen and do not indicate a malfunction.
 The LCD screen will be difficult to see if it is exposed to direct
sunlight.

When using a mobile phone, keep the aerial of the mobile
phone away from the LCD screen to prevent disruption of the
video in the form of disturbances such as spots or coloured
stripes.
Maintaining the LCD screen

When removing dust from or cleaning the LCD screen, first
turn this product off and then wipe the screen with a soft dry
cloth.
 When wiping the LCD screen, take care not to scratch the
surface. Do not use harsh or abrasive chemical cleaners.
LED (light-emitting diode) backlight
A light emitting diode is used inside the display to illuminate the
LCD screen.
 At low temperatures, using the LED backlight may increase
image lag and degrade the image quality because of the
characteristics of the LCD screen. Image quality will improve
with an increase in temperature.
 The product lifetime of the LED backlight is more than
10 000 hours. However, it may decrease if used in high
temperatures.
 If the LED backlight reaches the end of its product lifetime,
the screen will become dimmer and the image will no longer
be visible. In that case, please consult your dealer or the
nearest authorised Pioneer Service Station.

Specifications

General
Rated power source .......................................................... 14.4 V DC
( 12 V to 14.4 V allowable)
Earthing system ..........................................................Negative type
Maximum current consumption ...................................... .... 10.0 A
Dimensions (W × H × D):
D
Chassis ...................................... .... 178 mm × 100 mm × 165 mm
Nose ................................................... 171 mm × 97 mm × 18 mm
(AVH-X5850BT/AVH-X5850TV/AVH-X4850DVD)
Nose ..................................................... 171 mm × 97 mm × 3 mm
(AVH-X2850BT/AVH-X1850DVD)
Weight ..................................................................................... 1.8 kg
(AVH-X5850BT/AVH-X5850TV/AVH-X4850DVD)
Weight ..................................................................................... 1.6 kg
(AVH-X2850BT/AVH-X1850DVD)
Display
Screen size/aspect ratio .................................. 6.95 inch wide/16:9
(effective display area: 156.6 mm × 81.6 mm)
(AVH-X5850BT/AVH-X5850TV/AVH-X4850DVD)
Screen size/aspect ratio ............................... .... 6.2 inch wide/16:9
(effective display area: 137.52 mm × 77.232 mm)
(AVH-X2850BT/AVH-X1850DVD)
Pixels .................................................... .... 1 152 000 ( 2 400 × 480 )
Display method ........................................ TFT Active matrix driving
Colour system ........ PAL/NTSC/PAL-M/PAL-N/SECAM compatible
Audio
Maximum power output .....................................•50 W × 4 ch /4 Ω
•50 W × 2 ch /4 Ω + 70 W × 1 ch /2 Ω (for subwoofer)
Continuous power output ..... 22 W × 4 (50 Hz to 15 kHz , 5 %THD,
4Ω LOAD, Both Channels Driven)
Load impedance .............. 4 Ω (4 Ω to 8 Ω [2 Ω for 1 ch ] allowable)
Preout output level (max) ......................................................... 4.0 V
Equaliser (13-Band Graphic Equaliser):
Frequency ........ 50 Hz /80 Hz /125 Hz /200 Hz /315 Hz /500 Hz /800 Hz
/1.25 kHz /2 kHz /3.15 kHz /5 kHz /8 kHz /12.5 kHz
Gain .................................................................. ±12 dB (2 dB /step)
<Standard Mode>
HPF:
Frequency .......... 50 Hz /63 Hz /80 Hz /100 Hz /125 Hz /160 Hz /200 Hz
Slope .............–6 dB /oct, –12 dB /oct, –18 dB /oct, –24 dB /oct, OFF
Subwoofer/LPF:
Frequency .......... 50 Hz /63 Hz /80 Hz /100 Hz /125 Hz /160 Hz /200 Hz
Slope .............–6 dB /oct, –12 dB /oct, –18 dB /oct, –24 dB /oct, OFF
Gain ..................................................+10 dB to –24 dB (1 dB /step)
Phase ...................................................................... Normal/Reverse
Time alignment .....................................0 to 140 step (2.5 cm/step)
Bass boost:
Gain .......................................................................... +12 dB to 0 dB
Speaker level ....................................+10 dB to –24 dB (1 dB /step)
<Network Mode>
HPF (High):
Frequency ...... ..... 1.25 kHz /1.6 kHz /2 kHz /2.5 kHz /3.15 kHz /4 kHz
/5 kHz /6.3 kHz /8 kHz /10 kHz /12.5 kHz
Slope ..................... –6 dB /oct, –12 dB /oct, –18 dB /oct, –24 dB /oct
HPF (Mid):
Frequency 25 Hz /31.5 Hz /40 Hz /50 Hz /63 Hz /80 Hz /100 Hz /125 Hz
/160 Hz /200 Hz /250 Hz
Slope .............–6 dB /oct, –12 dB /oct, –18 dB /oct, –24 dB /oct, OFF
LPF (Mid):
Frequency ...... ..... 1.25 kHz /1.6 kHz /2 kHz /2.5 kHz /3.15 kHz /4 kHz
/5 kHz /6.3 kHz /8 kHz /10 kHz /12.5 kHz
Slope .............–6 dB /oct, –12 dB /oct, –18 dB /oct, –24 dB /oct, OFF
Subwoofer:
Frequency 25 Hz /31.5 Hz /40 Hz /50 Hz /63 Hz /80 Hz /100 Hz /125 Hz
/160 Hz /200 Hz /250 Hz
Slope .....–12 dB /oct, –18 dB /oct, –24 dB /oct, –30 dB /oct, –36 dB /
oct, OFF
Gain ..................................................+10 dB to –24 dB (1 dB /step)
Phase ...................................................................... Normal/Reverse
Time alignment .....................................0 to 140 step (2.5 cm/step)
Bass boost:
Gain .......................................................................... +12 dB to 0 dB
Speaker level ....................................+10 dB to –24 dB (1 dB /step)
DVD drive
System .........DVD-Video, VCD, CD, MP3, WMA, AAC, DivX, MPEG
player
63