Sony WX-900BT Manual De Instrucciones página 26

The sound skips during playback of a
BLUETOOTH audio device.
 Reduce the distance between the unit and the
BLUETOOTH audio device.
 If the BLUETOOTH audio device is stored in a case
which interrupts the signal, remove the audio
device from the case during use.
 Several BLUETOOTH devices or other devices
which emit radio waves are in use nearby.
 Turn off the other devices.
 Increase the distance from the other devices.
 The playback sound stops momentarily when the
connection between this unit and the cellular
phone is being made. This is not a malfunction.
The connected BLUETOOTH audio device cannot
be controlled.
 Check that the connected BLUETOOTH audio
device supports AVRCP.
Some functions do not work.
 Check if the connecting device supports the
functions in question.
A call is answered unintentionally.
 The connecting phone is set to answer a call
automatically.
Pairing failed due to a timeout.
 Depending on the connecting device, the time
limit for pairing may be short.
 Try completing the pairing within the time.
BLUETOOTH function cannot operate.
 Turn off the unit by pressing OFF for more than 2
seconds, then turn the unit on again.
No sound is output from the car speakers during
handsfree call.
 If the sound is output from the cellular phone, set
the cellular phone to output the sound from the
car speakers.
Siri Eyes Free is not activated.
 Perform the handsfree registration for an iPhone
that supports Siri Eyes Free.
 Set the Siri function on the iPhone to on.
 Cancel the BLUETOOTH connection with the
iPhone and the unit, and reconnect.
SongPal operation
Application name is mismatched with the actual
application in "SongPal".
 Launch the application again from the "SongPal"
application.
26
GB
While running the "SongPal" application via
BLUETOOTH, the display automatically switches
to [BT AUDIO].
 The "SongPal" application or BLUETOOTH
function has failed.
 Run the application again.
The "SongPal" application is automatically
disconnected when the display switches to [IPD].
 The "SongPal" application on iPhone/iPod does
not support iPod playback.
 Change the source of the unit to other than
[IPD], then establish the "SongPal" connection
(page 14).
Error displays/Messages
CD ERROR: The disc cannot be played. The disc will
be ejected automatically.
 Clean or insert the disc correctly, or make sure the
disc is not blank or defective.
CD NO MUSIC: There is no playable file. The disc
will be ejected automatically.
 Insert a disc containing playable files (page 22).
CD PUSH EJT: The disc could not be ejected
properly.
 Press  (eject).
HUB NO SUPRT: USB hubs are not supported.
IPD STOP: iPod playback has finished.
 Operate your iPod/iPhone to start playback.
OVERLOAD: The USB device is overloaded.
 Disconnect the USB device, then press SOURCE to
select another source.
 The USB device has a fault, or an unsupported
device is connected.
READ: Now reading information.
 Wait until reading is complete and playback
starts automatically. This may take some time
depending on the file organization.
USB ERROR: The USB device cannot be played.
 Connect the USB device again.
USB NO DEV: A USB device is not connected or
recognized.
 Make sure the USB device or USB cable is securely
connected.
USB NO MUSIC: There is no playable file.
 Connect a USB device containing playable files
(page 22).
USB NO SUPRT: The USB device is not supported.
 For details on the compatibility of your USB
device, visit the support site on the back cover.