Assembly - Craftsman 580.752090 Manual Del Operador

Your pressure washer requires some assembly and is ready
for use only after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your pressure
washer, please call the pressure washer helpline at
1-800-222-3136.
UNPACK PRESSURE WASHER
1. Remove everything from carton except pressure washer.
2. Open carton completely by cutting each corner from top
to bottom.
3. Remove pressure washer from carton.
CARTON CONTENTS
Check all contents. If any parts are missing or damaged, call
the pressure washer helpline at 1-800-222-3136.
• Main Unit
• Handle
• Accessory Tray
• High Pressure Hose
• Short High Pressure Hose
• Spray Gun
• Nozzle Extension with Quick Connect Fitting
• HydroFoam™ Wash
• Oil Bottle
• Hose Reel Kit
• Parts Bag (which includes the following):
• Operator's Manual
• Owner's Registration Card
• Safety Goggles
• Bag containing 3 multi–colored ProjectPro
• HydroFoam™ Launcher
• HydroFoam™ Launcher & Wash Instruction Sheet
• Fresh Start Fuel Cartridge
• Handle Fastening Hardware Kit (which includes):
• Wireform (1)
• Carriage Bolts (2)
• Plastic Knobs (3)
• Tree Clips (4)
Become familiar with each piece before assembling the
pressure washer. Identify all contents with the illustration on
page 6. If any parts are missing or damaged, call the
pressure washer helpline at 1-800-222-3136.
ASSEMBLING PRESSURE WASHER
Your Craftsman pressure washer will need assembly before
operation:
1. Fill out and send in registration card.
2. Attach handle and accessory tray.
3. Add oil to engine crankcase.
4. Attach hose reel.
5. Add fuel to fuel tank.
6. Connect high pressure hose to spray gun, hose reel and
pump.

ASSEMBLY

7. Connect water supply to pump.
8. Attach nozzle extension to spray gun.
9. Select/attach quick connect ProjectPro
extension.
Attach Handle and Accessory Tray
1. Place handle (A) onto handle supports (B) connected to
main unit. Make sure holes (C) in handle align with holes
(C) on handle supports.
C
NOTE: It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
2. Insert carriage bolts (A) through holes from back of unit
and attach a plastic knob (B) from front of unit. Tighten
by hand.
A
3. Insert spray gun holder wireform (A) through hole on
left side of handle (viewing from front of unit). Hold
® Nozzles
wireform in place and attach a plastic knob (B) from
inside of unit. Tighten by hand.
A
4. Place accessory tray (A) over holes (B) on handle
(viewing from front of unit). Push the tree clips (C) into
the holes until they sit flat against the accessory tray.
5. Insert multi–colored ProjectPro
provided in accessory tray. See How to Use Accessory
Tray.
7
® nozzle to nozzle
A
B
B
B
C
B
A
® nozzles in spaces