Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Attach Hose Reel
You will need the following tools to assemble the hose reel:
• 8 mm (5/16")wrench
• Phillips screwdriver
1.
Place hose reel onto left side of handle (A) (viewing from
handle side of unit) just above carriage bolt. Make sure
pin (B) in hose reel clamp inserts in hole (C) on handle.
A
C
B
NOTE: Make sure hose reel is attached to the handle facing
the engine.
2. Close hose reel clamp (A) and insert "T" bolt (B).
Tighten by hand.
3.
Remove shipping cap from fitting on hose reel and
attach one end of shorter high pressure hose to hose
reel fitting. Tighten by hand.
4.
Remove shipping cap from pump. Attach other end of
shorter high pressure hose to high pressure outlet on
pump. Tighten by hand.
5.
Uncoil high pressure hose and slide metal reinforced end
(A) through hole of hose reel.
A
6.
Attach high pressure hose to fitting on hose reel. Tighten
by hand.
7.
Slide hose clamp (A) onto high pressure hose. Using an
8 mm wrench and a phillips screwdriver, attach hose
clamp to hose reel with screw (B) and lock nut (C).
A
C
B
A
B
8.
Pull ring on pin and rotate to vertical position to lock pin
open.
9.
Pull hose reel handle outward and coil high pressure
hose onto hose reel.
10. Line up pin with hole in hose reel and pull ring on pin.
Rotate to horizontal position and let ring slide into
groove to lock hose reel in place.
8
Capítulos
Tabla de contenido
