Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Your cleaning system requires some assembly and is ready
for use only after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your
pressure washer, please call the pressure washer helpline
at 1-800-222-3136.
UNPACK THE PRESSURE WASHER
1. Remove everything from carton except pressure washer.
2. Open carton completely by cutting each corner from top
to bottom.
3. Remove pressure washer from carton.
CARTON CONTENTS
Check all contents. If any parts are missing or damaged, call
the pressure washer helpline at 1-800-222-3136.
•
Main Unit
•
Handle with Cleaning Tank Assembly
•
Accessory Tray
•
High Pressure Hose
•
Spray Gun
•
PrecisionSpray™ Selector
•
Detergent Siphoning Hose/Filter
•
Oil Bottle
•
Parts Bag (which includes the following):
•
Operator's Manual
•
Owner's Registration Card
•
Safety Goggles
•
Handle Fastening Hardware Kit (which includes):
•
Carriage Bolts (2)
•
"L" Bolt
•
Plastic Knobs (3)
•
Tree Clips (4)
Become familiar with each piece before assembling the
pressure washer. Identify all contents with the illustration on
page 6. If any parts are missing or damaged, call the
pressure washer helpline at 1-800-222-3136.
ASSEMBLING CLEANING SYSTEM
Your Craftsman cleaning system will need assembly before
operation:
1. Fill out and send in registration card.
2. Attach handle and accessory tray.
3. Connect detergent siphon hose to pump.
4. Add oil to engine crankcase.
5. Add fuel to fuel tank.
6. Connect pressure hose to spray gun and pump.
7. Connect water supply to pump.
8. Attach PrecisionSpray™ Selector to spray gun.
All manuals and user guides at all-guides.com
ASSEMBLY
Attach Handle and Accessory Tray
1. Place handle (A) onto handle supports (B) connected to
NOTE: It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
2. Insert carriage bolts (A) through holes from back of unit
3.
4. Place accessory tray (A) over holes (C) on handle
5. Insert supplied accessories in spaces provided in
7
main unit. Make sure holes (C) in handle align with holes
(C) on handle supports.
A
C
B
and attach a plastic knob (B) from front of unit. Tighten
by hand.
A
Insert "L" bolt (A) through hole on left side of handle
(viewing from front of unit). Hold bolt in place and attach
a plastic knob (B) from inside of unit. Tighten by hand.
A
(viewing from front of unit). Push the tree clips (B) into
the holes until they sit flat against the accessory tray.
accessory tray. See How to Use Accessory Tray.
B
B
C
B
A
Tabla de contenido
