Caster Wheels; V-Belts - Jonsered Z42F Manual Del Operador

MAINTENANCE
5. Remove the battery from the machine.
6. Rinse the battery with plain water and dry.
7. Clean terminals and battery cable ends with
wire brush until shiny.
8. Coat terminals with grease or petroleum jelly.
9. Reinstall battery.
Replacing battery
1. Install new battery with cable terminals routed
toward the center of the battery.
2. Reinstall battery hold-down and secure with
nuts removed in Step 4.
3. Reconnect RED battery cable to positive (+)
battery terminal with bolt and hex nut.
4. Connect BLACK grounding cable to negative
(-) battery terminal with remaining hex bolt
and hex nut.
5. Replace the terminal boot cover.

Caster Wheels

Check every 200 hours. Check that wheels rotate
freely.
Foam filled tires or solid tires will void the
warranty.
To replace, remove nut and caster bolt. Pull the
wheel out of the yoke and take care with the
spacer. Reinstall in reverse order. Tighten the
caster bolt and torque to 45 ft-lbs (61 Nm).

V-belts

Check at 100 hour intervals of operation. Check
for severe cracking and large nicks.
NOTE: The belt will show some small cracks in
usual operation.
The belts are not adjustable. Replace belts if they
begin to slip from wear.
Deck Belt Removal
1. Park on a level surface. Apply park brake.
2. Lower the deck into the lowest cutting
position.
3. Remove the bolts from the belt shields and
remove the shields.
4. Remove dirt or grass from around the cutter
housings and the deck surface.
5. Loosen the nut securing the belt guide. Pull
the belt guide up out of the idler arm.
6. Push inward on the idler arm to release the
tension on the belt.
7. Carefully lift the belt over the top of the cutter
housing pulleys and remove belt from the
deck.
Deck Belt Installation
NOTE: For ease in installing the deck belt, refer to
the routing decal on the top of the deck.
1. Wind the deck belt around the electric clutch
pulley located on the engine shaft.
2. Route the belt forward and up onto the deck.
3. Position the belt around spring loaded idler
pulley.
4. Wind the belt around the stationary idler pulley
and the mandrel housings.
5. Push inward on the idler arm and carefully put
the belt over the stationary idler pulley. When
the belt is correctly routed, slowly release the
idler arm to tension the belt.
6. Double check the belt routing to make sure it
matches the routing decal, and the belt does
not have twists.
7. Set the loosened belt guide into the idler arm
hole and tighten the pulley bolt.
8. Replace belt shields on both mandrel
housings and secure with fasteners.
25