Setting The Sensitivity - Waeco MagicWatch MWE800 Instrucciones De Montaje Y De Uso

_MWE-800-4F.book Seite 45 Freitag, 21. Juli 2006 4:28 16
MagicWatch MWE800
Caution!
Stop the vehicle immediately and check the situation (getting out if
necessary), if the following happens while you are parking:
The device first shows an obstacle while you park, and the sound
sequence speeds up normally (i.e. from slow to medium). Suddenly
the beeping sound slows down, or no obstacle is shown at all.
This means that the original obstacle is in the blind spot of the sen-
sors (construction-related characteristic), and it is possible to hit it.
8.2

Setting the sensitivity

The sensitivity has already been preset at the factory. Should it become nec-
essary to adjust the sensitivity, please proceed as follows.
➤ Slowly turn the setting screw of the control box (fig. 10.3, page 6) in the
minus direction as far as it goes.
➤ Set up a test object 1 m away from a sensor at a 90° angle (see fig. 20,
page 8).
➤ Switch on the ignition and activate the system with the switch on the dis-
play.
Now increase the sensitivity by slowly turning the setting screw in the plus
direction until the slow sound sequence (zone 1) becomes audible.
✓ This completes the sensitivity setting.
You can also set the operating time:
➤ Set the desired operating time with the rotary control (fig. 10.4, page 6).
If you turn the rotary control all the way to the left, the operating time will
be 5 s.
If you turn the rotary control all the way to the right, the operating time will
be 15 s.
All manuals and user guides at all-guides.com
Using MagicWatch
45