Waeco MagicWatch MWE800 Instrucciones De Montaje Y De Uso página 39

_MWE-800-4F.book Seite 39 Freitag, 21. Juli 2006 4:28 16
MagicWatch MWE800
When mounting the camera, proceed as follows:
➤ Follow the previous instructions to find a suitable installation location on
the front bumper.
Note
To facilitate installation, apply bright coloured tape (fig. 16.1,
page 7) over the entire width of the bumper to the mark the instal-
lation location (fig. 16.2, page 7)
➤ Remove the bumper.
➤ Check whether the it is at possible to drill holes a the points you marked
(no supports, reinforcements etc. are in the way).
➤ For each sensor, drill a hole in the bumper with a diameter of 22 mm (see
fig. 17, page 7).
To ideally adapt the sensor housing to the bumper, the installation sur-
face must be flat along a width of at least 25 mm.
➤ For a more accurate fit, slant the drill downwards slightly when drilling the
hole on the inside of the bumper. The sensor housing can now be inserted
downwards at a slight angle.
➤ Guide the cables of the sensors through the corresponding hole.
➤ Insert each sensor into the corresponding drill hole until it latches into
place.
➤ Re-mount the bumper to the vehicle.
6.3 Laying the sensor connecting cables
When laying the connecting cables, ensure that:
They are not kinked or twisted
They do not rub on edges
They are not laid in sharp edged ducts without protection (see fig. 3,
page 4).
Caution!
Before making any drill holes, ensure that no electrical cables or
other parts of the vehicle can be damaged by drilling, sawing and
filing.
All manuals and user guides at all-guides.com
Installing MagicWatch
39