Herschel SUMMIT 2600 Instrucciones De Instalación Y Funcionamiento página 4

In all cases the Herschel SUMMIT must be located in a position to allow proper and efficient use but one
that ensures hot parts are not touched accidentally.
The zone heated by the SUMMIT will increase in size the higher the heater is installed from the floor, but
the warmth experienced from the heater will be lower. The mounting height and intensity should reflect the
intended use of the heater.
Mount the heater at a lower height in areas intended for low physical activity (for example a seating area)
or areas subject to airflow (outside or near open doors).
Mount higher where less intense warmth is needed (for example warehouses where workers are active and
wear warm clothing).
Consideration should be given to any temporary or occasional additions such as stages or platforms and
adjusted accordingly. For areas with air movement/wind the directional Far Infrared spread may reduce by
1/3 to 1/2. In these areas, we recommend mounting at the lowest recommended height and proportionally
increasing the number of heaters. Power can also be adjusted with the 2600R model.
Wall/ceiling mount swivel brackets and accessories are provided with the heater which has been specifically
designed to allow this product to be fitted to a wall or ceiling with adequate clearances (140mm or 5.5") at
the back of the unit. The sides and ends of the heater must be positioned at least 300mm (12") away from
the nearest wall or other surface.
For longer distances from the ceiling, an optional wire suspension kit can be purchased from a
recommended supplier. Please contact Herschel for further information.
INSTALLATION:
Diagram 1: Swivel Bracket Assembly
Mounting Hardware Includes:
• 4 x bracket pieces (fit together to form 2 brackets with central pivot)
• 4 x bolts with expansion plugs (for fitting brackets onto ceiling or wall)
• 2 x slider plates (fit into grooves on rear of heater)
• 4 x small bolts and spring washers (to fit brackets onto slider plates)
• 4 x small bolts and spring washers with blind nuts (to form the pivot on the brackets)
• 2 x Thumb screws (fit into slider plates to clamp the slider plate in position on the heater).
ENGLISH