Device Elements - Kärcher NT 48/1 Manual Del Usuario

Device elements

1 Nameplate
2 Power cord
3 Holder for suction pipes
4 Holder for crevice nozzle
5 Drain hose
6 Suction hose
7 Suction head lock
8 Wheel
9 Dirt receptacle
10 Steering roller
11 Chassis handle
12 Floor nozzle
13 Suction tube
14 Suction support
15 Main switch
16 Suction head
17 Carrying handle
18 Cable hook
19 Bender
20 Cartridge filter
21 Fastening nut
22 Float
Start up
Dry vacuum cleaning
Caution
For dry vacuuming, the cartridge filter must
always be installed.
To vacuum fine dust, you can also use
–
an additional paper filter bag.
Inserting the paper filter bag
Illustration
Illustration
 Release and remove the suction head.
 Insert the paper filter bag.
 Insert and lock the suction head.
8
All manuals and user guides at all-guides.com
Inserting the rubber lips
Illustration
 Remove the brush strips.
 Install the rubber lips.
Note: The structured side of the rubber lips
must point outwards.
Remove the paper filter bag
–
Installing an additional filter
 Release and remove the suction head.
 Turn the suction basket by 180° and
 Loosen the mounting nuts
 Remove the cartridge filter.
Illustration
 Insert the fastening nut and tighten it.
 Install the additional filter.
 Insert and lock the suction head.
Illustration
The suction hose is equipped with a clip
system. All C-35/C-DN-35 accessories can
be connected.
 Plug in the main plug.
 Switch on the appliance at the main
–
–
 Switch off the appliance at the main
Illustration
 Empty the dirt container.
– 2
EN
Wet vacuum cleaning
To suck wet dirt, first remove the paper
filter bag.
keep it aside.
Clip connection
Operation
Turning on the Appliance
switch.
Emptying the dirt container
The vacuum channel is equipped with a
float.
When the dirt water reaches the highest
permissible level in the container, the
suction power is interrupted.
switch.
Drain off dirty water through the drain-
age hose.