Tabla de contenido
Idiomas disponibles
Idiomas disponibles
W
ATCHING TV
CHANNEL SELECTION
Select channels by pressing [CH K/L] found on
remote control or on the TV's control panel, or by
pressing [the Number buttons] found on the remote
control.
POWER
1
1
4
4
7
7
-
-
SETUP
BACK
VOL.
[CH K / L ]
• Use [CH K / L ] to change the channel.
• Same operation is also available with [CHAN-
NEL K / L ] on the top panel of the main unit.
[the Number buttons]
• Press the channel number with [the Number
buttons] to select a channel you want to watch,
then press [ENTER].
- When selecting analog channel 12
1
2
ENTER
- When selecting digital channel 12-1
Be sure to press [–] before entering the minor
channel number.
1
2
-
• If the channel broadcasts NTSC and ATSC both
and you don't press [–], you will receive the
NTSC channel only. The moment you press [–],
the lowest memorized digital channel will be dis-
played.
• Press [CH RETURN] to return to the previously
viewed channel.
NOTE:
• In DTV broadcasting, one channel sometimes broadcasts
multiple programs depending on the air time. In this case,
the main channel is called major channel and the minor
channel is called minor channel.
About minor channel broadcasting:
There may be different programs being broad-
cast on minor channels through a single chan-
nel from ATSC. You can watch each minor
channel program being broadcast by selecting
one of the minor channels.
18
EN
All manuals and user guides at all-guides.com
INPUT
SLEEP
SELECT
2
2
3
3
5
5
6
6
AUDIO
8
8
9
9
STILL
0
0
SCREEN
MODE
ENTER
ENTER
INFO
CH RETURN
CH RETURN
CH
CH
MUTE
MUTE
1
ENTER
NTSC
18:00
18:30
CH4
19:00
19:30
20:00
: change automatically
: change manually by pressing [CH
on your remote control
NOTE:
"No Signal" will appear on the screen after the minor
•
channel broadcast is over.
You will need to change the channel to continue
watching another TV program.
VOLUME ADJUSTMENT
This section describes how to adjust the volume.
The mute function, which turns the sound off and
on, will also be described.
BACK
CH RETURN
VOL.
VOL.
MUTE
[VOL. X / Y ]
• Use [VOL. X / Y ] to adjust the audio volume.
• The same operation is available with [VOLUME
X / Y ] on the top panel of the main unit.
• The volume bar will be displayed at the bottom
of the screen when adjusting the volume.
Volume
20
• The volume bar display will automatically dis-
appear in a few seconds.
[MUTE]
• Press [MUTE] to turn off and on the sound.
Mute
• "Mute" is displayed on the screen for a few sec-
onds.
• Press [MUTE] again or [VOL. X / Y ] ([VOLUME
X / Y ]) to release the Mute status.
ATSC
CH4-1
No signal No signal
CH4-1
CH4-2
CH4-3
CH4-1
No signal
CH4-3
CH4-1
CH4-2
No signal
/ ]
INFO
CH
Capítulos
Tabla de contenido
