Tabla de contenido
Idiomas disponibles
Idiomas disponibles
8. Wiring.
WARNING: Turn off circuit breakers to current fixture
from breaker panel and be sure switch is turned to the
OFF position
CAUTION: Be sure outlet box is properly grounded and
that a ground wire (GREEN or Bare) is present.
Make sure all electrical connections comply with Local
Codes or Ordinances and the National Electrical Code. If
you are unfamiliar with electrical wiring or if the
house/building wires are different colors than those
referred to in the diagram to the right, please use a
qualified electrician.
When downrod is secured in place on the hanging
bracket, wire the receiver as follows:
Connect 3-wire plug from remote control receiver to
3-wire plug from fan. Make sure plugs snap together
completely and pull extra wire slack from the upper
end of the downrod.
Connect BLACK wire from remote control receiver to
BLACK wire from ceiling with wire connector provided.
Connect WHITE wire from remote control receiver to
WHITE wire from ceiling with wire connector provided.
Connect all GREEN wires (from remote control receiver
and fan) together to BARE/GREEN wire from ceiling
with wire connector provided.
* Wrap each wire connector separately with electrical
tape as an extra safety measure.
Gently insert receiver (flat side up) into hanging bracket
and carefully push taped wire connectors into outlet
box. Let antenna rest outside of hanging bracket.
PLEASE NOTE: Wall and/or remote conrol must be
used for fan to operate. If you do not wish to use the
wall control, please proceed to Section 9 to continue
with fan installation.
IN ORDER TO WIRE WALL CONTROL, remove existing
wall switch. Wire the WALL CONTROL with wire
connectors provided as shown in diagram at right.
* Wrap each wire connector separately with electrical
tape as an extra safety measure. Gently push wires and
taped wire connectors into outlet box.
WARNING: CONNECT WIRES IN THE FOLLOWING
ORDER ONLY!
Connect GREEN/YELLOW ground wire from wall
control to ground wire from house or directly to one of
the screws from the outlet box.
Connect one BLACK wire from wall control to BLACK
(hot) lead wire from house. Connect second BLACK
wire from wall control to BLACK load wire to fan.
Attach wall control to outlet box and secure with
screws from original wall switch. Attach front plate to
wall control using 2 screws provided in the wall control.
ground (green
or bare)
ground (green or bare)
ground (green)
from fan
3-wire plug
from
receiver
ground (green/yellow)
(wiring for receiver)
Modifications not approved by the party responsible for compliance
could void the user's authority to operate the equipment.
*NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
*
Reorient or relocate the receiving antenna.
*
Increase the separation between the equipment and receiver.
*
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
outlet box
green/
bare
ground
black
black
(AC IN from
breaker box)
(wiring for wall control)
page 6
white supply wire
black supply wire
white
from ceiling
from receiver
antenna
white
AC IN N
black
AC IN L
receiver
wall
control
3 4
2
5
1
6
green/yellow
black (OUT to fan)
black
(TO POWER supply)
black
*
plate
Capítulos
Tabla de contenido
