Intended Use - Festool ST TKS 80 Instrucciones De Montaje

English
Contents
1 Symbols......................................................... 8

2 Intended use..................................................8

3 Parts of the device........................................ 8
4 Assembly....................................................... 8
5 Transportation.............................................. 9
6 Accessories................................................... 9
7 Environment..................................................9
1 Symbols
Warning of general danger
Read the operating instructions and
safety instructions.
Position markings for sliding table
plastic holders
Do not dispose of it with domestic
waste.
Tip or advice
Handling instruction
2 Intended use
The sliding table ST TKS 80 is intended to be
used as a sliding mechanism for sawing cross
and angled cuts with a bench-mounted circular
saw TKS 80 EBS.
The user is liable for improper or non-
intended use.
3 Parts of the device
[1-1] Removable leg
[1-2] Guide rail
[1-3]
Slide
[1-4] Two plastic holders
The specified illustrations appear at the begin­
ning of the Operating Instructions.
4 Assembly
The sliding table ST TKS 80 consists of a guide
rail [1-2] that is fitted on the left-hand side of
the TKS 80 EBS and a slide [1-3] that runs on
the guide rail [1-2].
8
All manuals and user guides at all-guides.com
4.1
Risk of accidents due to tilting power tool
► Always use the removable leg in conjunc­
► Make sure that the removable leg and the
Fitting the removable leg
The removable leg [2-1] is fitted to
the TKS 80 EBS before the guide rail is fitted.
► Loosen the rotary knob screws [2-2].
► Place the removable leg [2-1] on the rotary
► Tighten the rotary knob screws [2-2].
4.2
► Insert plastic holders [3-1] at position
► Insert the guide rail [3-5] into the V-
► Swivel the guide rail [3-5] downwards.
► Screw on the guide rail [3-5] with rotary
4.3
► Push the slide [4-4] with rollers [4-3] onto
4.4
Sliding table ST TKS 80 rolls off the guide
rail
Risk of accidents
► Screw on the end stops [5-9] to the two
4.5
Attach the preset profile setting rail [5-4] to the
V-profile of the slide [5-6].
Removable leg
WARNING
tion with the sliding table.
foldaway legs of the bench-mounted
circular saw are stable.
knob screws [2-2].
Installing the guide rail
markings for the plastic holder [3-3] from
behind and push upwards.
profile [3-4] from above at an angle so that
the Allen screw [3-7] is at the position
marking for the guide rail [3-6]. Therefore,
two rotary knob screws of the guide
rail [3-8] are located above both holes of
the plastic holders [3-2].
The guide rail [3-5] has three rotary
knob screws [3-8] and can therefore
be fixed in two positions: Protrusion at
the back or front.
knob screws [3-8].
Fitting the slide
the guide rail [4-2] from the side.
Fitting the end stops
WARNING
ends of the groove [5-2].
Fitting the preset profile setting rail