Table of Contents
Tips . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
Connections . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
Switching on . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5
Program sort . . . . . . . . . . . . . . . . . . . . . . . . . . . .6
Tips
Positioning the television set
Place your TV on a solid, stable surface, leaving a
space of at least 5 cm around the appliance.To
avoid danger do not expose the TV to water, or a
heat source (e.g. lamp, candle, radiator). Do not
obstruct the ventilation grid at the rear.
Adjustable stand.
The stand can be removed and replaced with a wall
mounting kit available as an option (ask your
dealer).
Poor reception
The proximity of mountains or high buildings may
be responsible for ghost pictures, echoing or
shadows. In this case, try manually adjusting your
picture: see Fine Tune (p.6) or modify the
orientation of the outside aerial. Does your
antenna enable you to receive broadcasts in this
frequency range (UHF or VHF band)?
No picture
Have you connected the aerial socket properly?
Have you chosen the right system? (p. 6). Poorly
connected euroconnector cables or aerial sockets
are often the cause of picture or sound problems
(sometimes the connectors can become half
disconnected if the TV set is moved or turned).
Check all connections.
No sound
If on certain channels you receive a picture but no
sound, this means that you do not have the correct TV
system. Modify the
setting (p. 6).
System
Recycling
°
The materials used in your set are either reusable or can be recycled.
To minimise environmental waste, specialist companies collect used appliances
and dismantle them after retrieving any materials that can be used again (ask your
dealer for further details).
All manuals and user guides at all-guides.com
Manual store . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6
Teletext . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8
16:9 Formats . . . . . . . . . . . . . . . . . . . . . . . . . . . .9
The amplifier connected to the TV does not deliver
any sound? Check that you have not confused the
audio output with the audio input.
PC mode doesn't work ?
Check that you have configured the computer on a
compatible display resolution (see p. 10).
Remote control
The TV set does not react to the remote control;
the indicator on the set no longer flashes when
you use the remote control? Replace the battery.
Standby
If the set receives no signal for 15 mins, it
automatically goes into standby mode.
To save power, your set is fitted with components that
give it a very low power consumption when in standby
mode (less than 1 W).
Cleaning the set
Only use a clean, soft and lint-free cloth to clean the
screen and the casing of your set. Do not use
alcohol-based or solvent-based products.
Still no results?
Disconnect the mains plug of the TV for 30
seconds then reconnect it.
If your TV set breaks down, never attempt to
repair it yourself: contact your dealer's after-sales
service.
. . . . . . . . . . . . . . . . . . . . . . . . .10
1