Intended Use; Assembly And Operation - Worx WX820 Manual Original

185*95mm
Finishing 3
sanding paper
125mm Random
orbit H&L 3
sanding paper
140*90mm
Detail H&L 3
sanding paper
76*30mm Fin-
ger H&L 3
sanding paper
100*50mm
Contour H&L 3
sanding paper
We recommend that you purchase your accessories from the same
store that sold you the tool. Refer to the accessory packaging for
further details. Store personnel can assist you and offer advice.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.

INTENDED USE:

This machine is intended for dry sanding of wood, plastic,
filler and coated surfaces. The sander is not to be used for
plaster or spackle.

ASSEMBLY AND OPERATION

ACTION
ASSEMBLY
Fitting &Replacing the Sanding Plate
Note: Read and understand the instructions before
assembling or changing sanding plates.
Note: Open the Hyperlock lever completely when
attaching or removing a sanding plate.
Note: When assembling the finishing plate/detail
plate, first check the assembling direction.
WARNING!The sanding plate must be
attached before starting the sander.
WARNING! Avoid pinching hands and
fingers when using the hyperlock™.
WARNING! Do not touch the bottom fan
after use to avoid high-temperature
burns.
Fitting the Sanding Paper
5-in-1 Multi Sander
3 3
3 3
3 3
3 3
3 3
FIGURE
See Fig.A1-A8
WORKING HINTS FOR YOUR
MULTI SANDER
If your power tool becomes too hot, especially when
used at low speed, set the speed to maximum and run
it with no load for 2-3 minutes to cool the motor. Avoid
See Fig.B1-B6
prolonged usage at very low speed. Always use sand
paper that is suitable for the material you want to sand.
Always ensure the work-piece is firmly held or clamped to
Attaching the Dust Bag
Caution:
To prevent the possibility of dust or a
foreign body being thrown into your face or eyes,
never attempt to use your sander without the dust
bag properly installed.
Charging the Battery Pack
Installing the Battery Pack
OPERATION
Switching On/Off
Using the Variable Speed Dial (Speed settings
1-6)
- The Variable Speed Dial can be used to set the
optimum speed according to the sanding plate used
and the respective application.
Sanding
Application
paper
Sanding down
180...400
varnishes
Sanding paint 40...120
Touching up
120...240
paintwork
Sanding wood 60...240
Machining veneer 180...240
Derusting metal 40...120
Sanding metal and
120...240
steel
Sanding curved
60...240
surface
Removing the Battery Pack
Emptying the Dust Bag
-For more efficient operation, empty dusts bag
every 5-10 mins.
See Fig. C
See Fig.
D1,D2,D3
See Fig. E
See Fig. F
Speed
3-6
4-6
See Fig. G
1-5
1-6
3-5
4-6
4-6
1-6
See Fig. H
See Fig. I1-I2
EN
13