System Description; Operation - Orkli OSKOL-150 Manual De Usuario

Upon completion of device installation, the installer should send in the completed warranty form.
The goods will be taken to be compliant and suitable if:
• The device under warranty is that which are working, and has been installed and operates according to applicable
legislation and the manufacturer's instructions.
• Start-up - this date determines the start of the warranty period - and all potential repairs are carried out by qualified
personnel or Technical Support.
• Official spares are used as determined by Technical Support.
• The working fluid will have a pH of between 5 and 9 at 20°C, and a salt content adjusted in accordance with the
following points:
a) primary circuit water salinity must not exceed 500 mg/l total soluble salt. If this value is not available conductivity
will be taken as limiting variable, and shall not exceed 650 _S/cm;
b) calcium salt content must not exceed 200 mg/l, expressed as calcium carbonate content;
c) limit for free carbon dioxide in water must not exceed 50 mg/l.
The warranty expressly excludes faults produced by:
a) improper product use, or not following the instructions contained in the instruction manual and other documentation
provided for installation and maintenance.
b) Any type of overload.
c) Freezing.
d) Equipment handling by non-approved personnel.
e) Faults produced by force majeure (atmospheric, geological phenomena, etc.).
4.

SYSTEM DESCRIPTION

4.1 Operation

The system designed by Orkli S. Coop. incorporates the benefits of a separate solar system but with much simpler and
faster installation and maintenance. In turn Orkli S. Coop. has opted for the architectural integration of the solar system.
Primary recirculation pump regulation is achieved via an incorporated photovoltaic cell. This peculiarity means that
the pump starts working when there is capacity to exploit solar energy. And because it is a device that varies its power
depending on the amount of solar radiation, an optimum result is achieved, avoiding performance penalties.
AF
Orkli S.Coop. recommend installers install a thermometer at the auxiliary system inlet so that the user can observe the
behaviour of the OKSOL-150 collector.
All manuals and user guides at all-guides.com
1
2
AF
Tank safety valve output 4.5 bar and 95º
1
Primary circuit safety valve output 3 bar
2
Cu 1/2"
ACS
Cu 1/2"
15