Nuna Pipa Lite Manual Del Usuario página 18

3
While pressing the base into the vehicle seat
(50)-1, tighten the vehicle belt by pulling
straight along the belt path (50)-2, keeping
both belts laying flat in the lock off.
4
While the shoulder belt is tight, hook the
bottom of blue lock off and press to close the
lock off on the shoulder and lap belt. (51)
The installed base is shown as (52)
Please ensure that there is no gap between the
vehicle seat and the bottom of the base.
The safety belt must go under the lock off, not
over the lock off. (52)-1
The safety belt must be locked into the buckle.
(52)-2
The load leg must be installed correctly with
green indicator. (52)-3
The child restraint can not be used if the
vehicle safety belt buckle (female buckle
end) is too long to anchor the child restraint securely. (52)-4
5
After child is properly secured in infant carrier,
press Child Restraint on base and listen
for a click. Pull on Child Restraint to verify
installation. (53)
DO NOT allow Child Restraint to contact the
vehicle door or seat in front of it.
21
PIPA lite Instructions
6
To release the Child Restraint, pull the infant
carrier up (54)-2 while squeezing the infant
carrier release button located on the base.
(54)-1
7
To remove the base, lift up on the the lock off.
(55)
8
Unbuckle the vehicle belt and un-route the
shoulder and lap belt from the base. (56)
Then remove the base.
Installation on a Stroller
This infant carrier can attach to Nuna strollers
using adapters. Instructions are included with the
adapters, which are sold separately.
This infant carrier can also attach to other brands
of strollers using adapters. Please visit nunababy.
com for more information.
22
PIPA lite Instructions