Product Overview; Installation Concerns; Handle Adjustment - Nuna Pipa Lite Manual Del Usuario

Product Overview

Canopy
1
To assemble the canopy, push canopy mounts
into fabric slot to attach to the seat. (1) A click
sound means the canopy mounts is locked
completely. (2)
2
Stick the hook and loop fasteners on the rear of
canopy and seat. (3)
3
Snap the canopy to the canopy mount on both
sides. (4)
4
To open the canopy, pull the canopy toward the
front of the seat, and to close the canopy, push
it back.
5
To remove the canopy, reverse step 1. Then
unsnap the seat pad from the shell and lift
fabric up. (5)
6
Press the canopy release button (6)-1 and pull
canopy through the fabric slot. (6)-2 Repeat on
opposite side.
Seat Pad
1
Open the snaps on both sides of the seat. (7)
2
Press the red button to disengage the buckle.
Remove the body support.
3
Remove the seat pad. (8)
13
PIPA lite Instructions

Installation concerns

DO NOT install this infant child restraint on
vehicle seats with 2-Point Retractor Safety
Belts with the Base. (9)
This infant child restraint is suitable for vehicle
seats with a 3-point Retractor Safety Belt with
the Base (10), or ISOFIX anchor points WITH
the Base. (11)
DO NOT place rear-facing child restraint on
front seat with air bag. Death or serious injury
may occur. (12) Please reference vehicle
owner's manual for more information.
DO NOT install this infant child restraint on
vehicle seats that face sideways or rearward
with respect to the moving direction of the
vehicle. (13)
It is recommended to install this infant child
restraint on the rear vehicle seat. (14)
DO NOT install this infant child restraint on
vehicle seats unstable during installation.

Handle Adjustment

1
The infant carrier handle can be adjusted to 3
positions. (15)
2
To adjust the handle position, squeeze handle
adjustment buttons on both sides. (16)-1 Rotate
handle until it clicks into any of the 3 positions.
Handle can be used in vehicle in any locked
position. (16)-2
14
PIPA lite Instructions